PROGRAMMING DEVICE CONTROL
The One For All 4 Device Universal Remote Control is preprogrammed at the factory to operate an RCA TV, a Toshiba DVD player, a Motorola cable box, and an RCA VCR. To control devices other than the default brands, perform the following steps; otherwise skip this section:
- Turn on a desired device (e.g.,VCR or DVD player) and, if applicable, insert media (e.g., cassette or disc). NOTE: Please read steps 2 through 4 completely before proceeding. Highlight or write down the codes and device you wish to program before starting step 2.
- On the remote control, press a device key once (i.e., VCR/PVR, DVD, CBL/SAT, or TV). NOTE: To program control of a VCR, PVR (or DVR),TV/VCR Combo, or TV/VCR/DVD Player Combo press VCR/PVR once. After programming a VCR Combo device, you will be able to control channel selection, volume, and VCR functions. NOTE: To program control of a DVD Player, DVD Player/VCR Combo, or TV/DVD Player Combo, press DVD once. After programming a DVD Combo device, you will be able to control channel selection, volume, and DVD functions. NOTE: To program control of a Cable Box, Cable Box/PVR (or DVR) Combo, Satellite Receiver, or a Satellite Receiver/PVR (or DVR) Combo, press CBL/SAT once.
- Press and hold SET until the LED (red light) blinks twice, then release SET.
- Use the Manufacturer’s Codes (starting on page 18) to locate the type of device and brand name and then enter the first four-digit code for your device. If performed correctly, the LED will blink twice. NOTE: If the LED did not blink twice, repeat steps 2 through 4 and enter the same code again.
- Aim the remote control at the device and press POWER once. The device should turn off. If it does not, repeat steps 2 through 5, trying each code for your brand until you find one that works. If it still doesn't work, try Searching For Your Code below. NOTE: If the device does not have a POWER key, press PLAY.
- Repeat steps 1 through 5 for each device you want to control. For future reference, write down each working device code.
|
SEARCHING FOR YOUR CODE
If your device does not respond to the remote control after trying all codes listed for your brand, or if your brand is not listed at all, try searching for your code.
NOTE: Before performing a code search for a DVD player or VCR, turn on the device and insert the required media. For example, to search for a code for your TV:
- On the remote control, press TV once.
- Press and hold SET until the LED (red light) blinks twice, then release SET.
- Enter 9 - 9 - 1.The LED will blink twice.
- Aim the remote control at the TV and slowly alternate between pressing POWER and TV. Stop when the TV turns off (after pressing POWER). If the device does not have a Power key, you can substitute another function, such as digits 0 ~ 9 , CH Up, or PLAY). NOTE: In the search mode, the remote control will send IR codes from its library to the selected device, starting with the most popular code first.
- To lock in the code, press and release SET. The LED will blink twice.
- To search for the codes of your other devices, repeat steps 1 through 5, but substitute the appropriate devi
|
Comments
0 comments
Article is closed for comments.