Getting Started using the RCA RT2600 Home Theater System

Getting Started Using the RCA RT2600 Home Theater System

Set up and Maintenance of the Receiver 

• Provide spaces for sufficient ventilation as indicated:
   
• Do not connect to the AC power cords until all connections are completed.
• Do not use your set immediately after transferring it from a cold place to a warm place: there is risk of condensation.
• Do not expose your set to water and excessively high temperatures.
• After having disconnected your set, clean the case with a soft cloth, or with a slightly damp leather chamois. Never use strong solvents.

Inserting Batteries into Remote Control

Insert two AA(R6) batteries according to the + and - signs on the battery compartment. To use the remote control, point it directly at your receiver. Whenever a button is pressed, a red indicator will light up on the remote control.

Install batteries as follows:

1. Remove battery compartment door by applying thumb pressure on battery door and then lift the door out and off the cabinet.
2. Insert 2 AA batteries in the compartment and replace the compartment door.

Connecting to Audio-Visual Components

Digital Connections

Read instructions carefully when connecting components to the receiver. Digital In Jacks can accept Dolby Digital (AC-3), DTS (RT2600 only) or PCM signals when compatible components are connected.

AM Loop Antenna and FM Indoor Antenna

1. Uncoil the Antenna wire and locate the base end of the AM antenna and snap into place as shown below in AM Loop Antenna.
2. Press down on the Antenna tab to open the terminal.

AM Loop Antenna:

Hints:

• For FM reception, extend antenna to its full length and arrange the Antenna as a T Shape.
• For AM reception, rotate the antenna horizontally to get better reception.

Connecting the Antennas

The AM and FM antennas connect to the AM and FM terminals on the system’s back panel. They must be hooked up in order to receive clear reception.

Connecting the Speakers

Speakers: There are 6 speakers equipped with the unit (2 front, 1 center, 2 rear, 1 subwoofer). In order to enjoy good surround effects, all six speakers need to be connected