|
Using the On-screen Menu feature on the RCA RCU404 Remote Control |
|
|
This remote cannot access every menu system of all models and brands of consumer electronics components. However, if you've successfully programmed the DVD•AUX key to operate a DVD player, you can access DVD disc menus with the MENU key. The MENU key will also access TV menu systems for most RCA, GE and PROSCAN TV's, as well as some other popular brands. Also, some RCA VCR menus are supported by this remote’s menu key. This remote also supports select satellite receiver menus. If this remote’s MENU key doesn't access the menu system for your component, you'll need to use the original remote to change menu settings. Note: This remote’s MENU key doesn't support cable box menu systems and some VCR menu systems. |
|
|
Accessing a Menu System 1. Make sure your components are turned on and your TV is set to the component's input. 2. Press the component key on the remote (TV, VCR, DVD•AUX, or DBS•CABLE). 3. Press the MENU key. The indicator light blinks continuously to indicate the remote is in Menu Mode and the component’s menu should appear on the TV screen. |
|
|
Highlighting and Selecting Menu Items
Notes: All functions in competitive models and brands of products may not be fully supported. The remote will automatically time out in Menu Mode and the indicator light will stop blinking after approximately 10 seconds of inactivity (no keys being pressed). For DVD menus, the Menu Mode will time out after approximately 15 seconds. Because of the wide variety of menu formats, some experimenting may be required. |
|
|
Exiting a Menu System To exit Menu Mode, press the corresponding component key on the remote (TV, VCR, DVD•AUX, or DBS•CABLE). The indicator light goes out and the remote reverts to its normal mode of operation. |
|

Comments
0 comments
Article is closed for comments.