Programming and Operating the RCA D770 Universal Remote Control

Programming and Operating the RCA D770 Universal Remote Control

Battery Installation 

Your universal remote requires 2 new AA alkaline batteries (sold separately).

1. On the back of the remote, push down on the cover and slide it off.
2. Insert the batteries, matching the batteries to the (+) and (-) marks inside the battery case.
3. Slide the battery cover back into place.

Note: Reprogramming may be required after batteries are replaced.

Key Description

ANTENNA: In TV Mode, lets you switch the source of the video signal from satellite signals to an off-air antenna or cable signal when using the OUT TO TV jack. In VCR Mode, it functions as a TV/VCR input key.

ARROWS: Use the navigation arrows to move the on-screen highlight up, down, left, or right. Using the arrows to highlight a menu item is also called “pointing.”

CH + (UP)/ - (DOWN): Use to scan up and down through the channels in the current channel list. If you are in the program guide or menu system, use the CH +/- keys to page up and down a screen at a time. You can also use the CH +/- keys on the top of the digital satellite receiver to change the channel.

CLEAR: Removes the on-screen displays and returns you to normal viewing.

COMPONENT KEYS: When programmed, these keys are used to put the remote in a specific mode so that it can control that component.

• AUX1 and AUX2: Act as “wildcard” keys. They can be programmed to control another TV, VCR, DVD, satellite receiver, cable box, or an audio component. Follow the direct entry programming instructions on page 7 to program these keys.
  Note: The AUX1 key is pre-programmed with codes to control a Dish Network digital satellite receiver.
• DVD: Puts the remote in DVD Mode.
• SAT: Puts the remote in SAT Mode. This key is pre-programmed to control an RCA DIRECTV® digital satellite receiver manufactured before 2004.
  Note: This key cannot be reprogrammed. If the SAT key doesn't control your receiver, use the AUX1 key to program the remote to control your satellite receiver if it was purchased after 2003.
• TV: Puts the remote in TV Mode.
• VCR: Puts the remote in VCR Mode.

Digit Keys (0-9): Use the digit keys to tune directly to a three-digit satellite channel or non-satellite channel. If a satellite channel number is less than four-digits long, you must press OK after entering the channel number. If you are in the menu system, use the digits to highlight and select items. Use 0 to return to the previous menu screen.

FETCH: Either brings up the Fetch menu or tells the receiver to take the action you programmed it to take.

GO BACK: Moves you back and forth between the last two selected channels. In the menu system, returns you to the previous screen.

GUIDE: Brings up the program guide. Subsequent presses of the GUIDE key switch between the Detail and Grid guide formats.

INFO: Brings up the on-screen channel banner, password challenge, or purchase offer screen. Press again to get program details. In the program guides, press INFO to get information about the highlighted program or chann