Setting the Clock and Using Display on the RCA RPC100 Clock Radio

Setting the Clock and Using the Display on the RCA RPC100 Clock Radio 

Before plugging for power 

1. Set the Time Zone Slide the time zone selector at the bottom of the unit to Eastern, Central, Mountain or Pacific. (Refer to the maps on the right)

2. Set the Daylight Saving Time Slide the day light saving selector at the bottom of the unit to turn on/off in areas observing/not observing such time change. The icon shows on the display when daylight saving time is active.

WARNING: Please avoid playing with these buttons after entering the Clock/ Alarm set mode.

Auto clock set
You do not have to set the clock time as a built-in automatic time set system is equipped in this clock powered by 3V (2 X AA batteries, included). All you have to do is to plug this clock for power and current time will be shown automatically. However, the batteries can also be exhausted and we recommend that you replace the batteries every year.

Display

Display brightness
Rotate DISPLAY on the left of the unit to increase or decrease the display brightness.

Night light
To select the night light setting: Night light is located at the bottom of the unit. Slide LIGHT on the left of the unit to select one of the following settings:
• ON – always turns on the night light;
• AUTO – turns on the automatic night light mode;
• OFF – always turns off the night light.

To use the automatic night light mode:
• Press SNOOZE/LIGHT to turn on the night light for about 5 seconds.
• The night light also turns on when the wake function activates.

You can access the User's Manual here.