Programming the RCA RCR815 Universal Remote

Programming the RCA RCR815 Universal Remote  

Your universal remote can operate a variety of brands of components. You need to program the remote with the codes that match the components (See Code Lists enclosed). These codes enable the remote to communicate with your components. Each brand and each component has its own “language,” and, by programming the correct codes into your remote, you tell the remote to “speak the same language” as your components.

In order to control combo units, like TV/VCRs, TV/DVDs or TV/VCR/DVDs, use the combo codes in the Code List to program the individual corresponding component keys. Once programmed successfully, the TV key controls the TV functions on your unit, and the DVD or VCR key controls the DVD or VCR functions, respectively. The codes in the combo section should be tried first, using Direct Code Entry on the TV and DVD or VCR keys. If this is unsuccessful, use Manual or Auto Code Search to program the remote to control your combo unit. Throughout the programming of each key, keep the remote pointed at the IR sensor of the component you are currently programming the remote to control.

Brand Code Search and Entry
If your brand is listed in the Brand Code List (See Code Lists enclosed), you may be able to program your universal remote by searching through only the Code Lists for that specific manufacturer. Brand Code Search and Entry can be the quickest method to program your remote. If your brand is not listed in the Brand Code List, use one of the other programming methods.

NOTE: Brand Code Search and Entry is supported for TV, VCR, DVD and SAT/CBL brands. You cannot use the Brand Code Search method for AUDIO, DVR and HDTV.

Follow these instructions to program your remote using the Brand Code Search and Entry method. To exit without saving at any point in the Brand Code Search, press and release the CLEAR key.

1. Manually turn on the component you want the remote to control.
2. Locate the Brand Codes in the Code Lists.
3. Press and hold the component key you wish to program. The illuminated ON·OFF key turns on and remains on.
4. While holding the component key down, press and hold the ON·OFF key. The illuminated ON·OFF key turns off.
5. After holding both keys down for three seconds, the illuminated ON·OFF key turns back on.
6. Release both keys. The illuminated ON·OFF key remains on.
7. Refer to the Brand Codes. Press and release the appropriate brand code key (Numbers 0-9), using the number keys. The illuminated ON·OFF key blinks once.
   • Note: If you do not press a valid Brand Code Search key, the illuminated ON·OFF key blinks four times and turns off. The last programmed code under that component key is retained.
8. Press and release the ON·OFF key repeatedly until your component turns off. Each time you press the ON·OFF key, the illuminated ON·OFF key blinks, and the next code is sent. The Brand Code Search begins with the first code in the chosen brand list for that component and cycles through all the codes for that brand. If your component turns off, you have found the correct code. (If it cycles through and the illuminated ON·OFF key blinks four times and turns off, all codes in the chosen brand list have been searched and another programming method should be tried. The Brand Code Search mode is exited.)
9. Once you have found the correct code, save that code by pressing and releasing the STOP key. The illuminated ON·OFF key turns off. You must press the STOP key to save the code or the correct code will not be stored!
10. To confirm that the component key is programmed with the correct code for maximum functionality, test the component. Attempt to control a variety of