Programming the One-For-All URC6131 Universal Remote Control

Programming the One-For-All URC6131 Universal Remote Control

Programming Device Control 

The One For All 6-Device PVR Universal Remote Control is preprogrammed at the factory to operate an RCA TV, VCR, and satellite receiver, a Philips Tivo PVR, a Toshiba DVD player, and a Pioneer audio receiver/amplifier.To control devices other than the default brands,perform the following steps; otherwise skip this section:

NOTE: For DVD Player/VCR Combo control, see the next page.

1. Turn on a desired device (e.g.,VCR or DVD player) and, if applicable, insert media (e.g., cassette or disc).

NOTE: Please read steps 2 through 4 completely before proceeding. Highlight or write down the codes and device you wish to program before starting step 2.

2. On the remote control,press a device key once (i.e., TV,PVR,DVD, CBL/SAT,AUD,or VCR).

NOTE: To program control of a cable box or satellite receiver, press CBL/SAT once.

NOTE: To program control of a CD player or audio receiver, press AUD once.

NOTE: To program control of a TV/VCR Combo, press VCR once. After programming, you will be able to control channel selection, volume, and VCR functions.

NOTE: To program control of a TV/DVD Player Combo, press DVD once. After programming, you will be able to control channel selection,
volume, and DVD functions.

3. Press and hold SET until the LED (red light) blinks twice, then release SET.

4. Use the Manufacturer’s Codes (starting on page 17) to locate the type of device and brand name and then enter the first four digit
code for your device. If performed correctly, the LED will blink twice.

NOTE: If the LED did not blink twice, repeat steps 2 through 4 and enter the same code again.

5. Aim the remote control at the device and press POWER once.The device should turn off. If it does not, repeat steps 2 through 5, trying each code for your brand until you find one that works. If it still doesn't work, try Searching For Your Code on page 11.

NOTE: If the device does not have a POWER key, press the (Play) key.

6. Repeat steps 1 through 5 for each device you want to control.
For future reference,write down each working device code

Programming DVD Player/ VCR Combo Control

1. Turn on the DVD Player/VCR Combo and insert a DVD.

NOTE: Please read steps 2 through 4 completely before proceeding. Highlight or write down the codes and device you wish to program before starting step 2.

2. On the remote control, press DVD.Next, press and hold SET until the LED (red light) blinks twice, then release SET.

3. Use the Setup Codes For DVD Player/VCR Combos (on page 21) to locate the brand name and then enter the first four-digit code for your device. If performed correctly, the LED will blink twice.

<blockquote style