Using Keymover on the One-For-All URC6131 Universal Remote Control

Using Keymover on the One-For-All URC6131 UniverControlsal Remote 

Using Keymover 

The One For All 6-Device PVR Universal Remote Control includes a Keymover feature that allows you to map (or copy) keys from one mode (i.e., source mode) to another mode (i.e., destination mode).

NOTE: The following keys cannot be used as a source or destination: TV, PVR, DVD, CBL/SAT, AUD, VCR, and SET.

Programming Keymover

For example, if your VCR does not have volume control, you can map those keys (i.e., VOL+, VOL-, and Mute) from the TV mode to the VCR mode as follows:

1. Press and hold SET until the LED (red light) blinks twice, then release SET.
2. Enter 9 - 9 - 4.The LED will blink twice.
3. For the source mode, press TV once.
4. For the source key, press VOL+ once.
5. For the destination mode, press VCR once.
6. For the destination key, press VOL+ once.
7. The LED will blink twice indicating the keymoved sequence is correct.
8. Repeat steps 1 through 7 twice more to map remaining volume control keys, substituting VOL- and Mute as source and destination keys in steps 4 and 6.

Upon completion of the above procedure, you can now use your One For All 6-Device PVR Universal Remote Control to control the TV’s volume and mute in the VCR mode, as well as in the TV mode.

Restoring Keymoved Keys to Default Settings

Restoring A Single Keymoved Key

1. Press a device key that has a keymoved key.
2. Press and hold SET until the LED (red light) blinks twice, then release SET.
3. Enter 9 - 9 - 4.The LED will blink twice.
4. Press the destination key twice (where the keymoved key is stored).The LED will blink twice.

Restoring All Keymoved Keys In A Single Mode

1. Press and hold SET until the LED (red light) blinks twice, then release SET.
2. Enter 9 - 9 - 4.The LED will blink twice.
3. Press the destination mode twice (where keymoved keys are stored). The LED will blink twice.

You can also access the User's Manual here.