Installation Instructions for the RCA ANT3038XR Outdoor Antenna

Installing the RCA ANT3038XR Outdoor Antenna
	Connect the reflector booms to the front (small) boom: Find the two reflector booms and the front (or small) boom. The two smaller elements on the reflector booms face away from the small main boom. IMPORTANT: Unfold the elements on each end of the reflector boom so that the front of their locking tabs face towards each other. The remaining locking tabs can be unfolded in either direction. Make sure that all of the elements are perpendicular to the reflector boom. Connect the two reflector booms to the front boom using two of the provided #10 nuts and screws. The reflector booms should be parallel to the smaller boom at this point. (See Fig. 1.) Unfold the rest of the antenna: Unfold all the other elements on the antenna until they lock into place ensuring that they are flat and parallel to each other. (See Fig. 3.)
Connect the middle (large) section to the front (small) section: Find the middle (large) section. Locate the end of the middle section that matches figure 4. Remove the nut and screw in the center. Slide the narrow boom of the front (small) section into the middle (large) section. Make sure the phasing lines are on the top side of the small boom and the black plastic element holders are also on this same side. This is the top of the antenna. (See figure 5.) Tap lightly with a rubber mallet on the end of the small boom aligning the holes for the screw. (See figure 4.) Re-install the screw and nut; be sure to tighten securely. Connect the phasing lines: Place the phasing lines from the front section over the studs. Secure them to the studs with #10 flange nuts and washers. Tighten securely.
Connect the rear section to the middle (large) section: On the open end of the middle (large) section, remove the rear nut and screw. Find the rear section. Slide the narrow boom of the rear antenna into the middle (large) section. Tap lightly with a rubber mallet on the end of the small boom, aligning the holes for the screw. (See figure 6.) Re-install the screw and nut; be sure to tighten securely. <img border="0" alt="Image" src="http://www.voxxintl.com/images/common/ANT3038XR/ANT3038X