Installation of the AR ARHT10 Surge Protector

Installation of the AR ARHT10 Surge Protector

Power Connections 

1. Plug the surge protector into a grounded 3-prong outlet only.
2. Plug all connected equipment directly into the surge protector.
3. Press the master power switch to turn on the surge protector.

Indicator Lights:

• The Protected light should be on when the power switch is turned on when the surge protector is plugged into an outlet.
• The Grounded light should be on when the surge protector is plugged into an outlet. If the light does not come on when you turn on the surge protector, There's a ground wiring problem and you should contact an electrician to properly ground the outlet. Connecting your surge protector to an improperly grounded outlet will void all Audiovox warranties.

USB Charging

The 2.1 USB Charge outlet on this charger is optimized for use with certain types of devices such as the iPad®. As a result, the
2.1 USB Charge outlet may not charge all models of all brands of your mobile devices. If any of your devices will not charge using the 2.1 USB Charge outlet on this charger, use the other USB Charge outlet to charge that device.

This surge protector is designed to charge two devices simultaneously. However, if you plug in two devices to charge simultaneously and their combined power requirements exceed the power capacity of this surge protector, this surge protector will shut down to protect your devices. In that case, try charging each device by itself.

Ethernet Connections

If you are using an Ethernet network data line, pass the connection through the protected Ethernet jacks on your surge protector. Most network card or modem damage can be prevented if you connect the CAT. 5 or CAT. 6 cable through the surge protector.

1. Connect the CAT. 5 or CAT. 6 cable from your wall outlet to the INPUT jack on the surge protector.
2. Connect a CAT. 5 or CAT. 6 cable into the OUTPUT jack on the surge protector.
3. Connect the other end of the CAT. 5 or CAT. 6 cable to the jack of the network card or modem you want to protect.

Sat/Coax Cable Connections

If you are using a coax cable, pass the connection through the protected coax jacks on your surge protector. Most TV/VCR damage can be prevented if you connect the coax cable through the surge protector.

1. Connect the Cable/Antenna line from your source to the INPUT jack on the surge protect