Installation of the Advent ACA600 Mini-bullet back-up camera

Installation of the Advent ACA600 Mini-bullet back-up camera

Installation 

Professional Installation Is Recommended!

This camera is designed to be mounted at the rear of the vehicle. Find a location that won't obstruct any equipment on your vehicle & will allow you to safely route the power/video cable into the vehicle.

Caution: Don't block or obstruct airbags or any safety device. All connections should be made inside the vehicle as the power and video connection are not waterproof. Always check twice before drilling a hole or screwing into something to insure there is nothing behind that surface.

1. Connect the RED power cable to the 12 Volt Positive wire from your White Reverse Lamp.
2. Connect the Black power cable to a 12 Volt Ground (Example a screw or bolt).
3. Connect the video output (yellow) connection to the included extension cable and route the cable to the front of the vehicle.
4. Connect this to your Monitor's rear view camera input.
5. Adjust the camera angle/direction to optimize your view on your monitor and tighten the mounting screws.

When using the "flush Mount" method always double check to make sure you do not hit anything behind your mounting surface. The drill bit included is designed for plastic bumpers and trim panels.

If you mount this in Metal you will need a metal hole saw (NOT INCLUDED). Use a 16.5mm metal cutting hole saw if needed. It is always a good idea to cover or protect the area around your mounting location with masking tape before drilling.