Troubleshooting the Audiovox AXDVD1 Blu-Ray Player

Troubleshooting the Audiovox AXDVD1 Blu-Ray Player
Problem:	Solution:
Why won't the AXDVD1 turn on?	The power wires are not connected properly. Make sure the connection is correct. The fuse has blown. After checking for short circuits in the wires, replace the fuse with a fuse of the same rating. The internal processor is not working correctly. Press the reset button to restore the unit to factory defaults.
Why isn't the remote control to the AXDVD1 operating correctly?	There is no battery in the remote control. Install a CR2025 lithium battery in the remote control. The remote control battery is depleted. Install a new battery. The remote control isn't pointed to the remote sensor. Make sure that the remote control is pointed to the remote control sensor. The remote control is out of it’s operating area. Make sure the remote control is within the operating area.
Why does the AXDVD1 stop working when a USB device or memory card is inserted?	The connected USB device or the memory card is probably not a certified one. The DVD player cannot play an uncertified USB device or memory card. In case the DVD player stops working, turn it off and unplug the USB device and/or memory card from the DVD player. Turn on the DVD player again. The DVD player will resume the normal operation.
Why won't a disc play on the AXDVD1?	Disc is poor quality, damaged or not clean. Clean or replace the disc. The disc installed is the wrong region or not supported by the DVD player. Check the disc type. Press the reset button.
Why can't I change the viewing angle on the AXDVD1?	The DVD disc does not contain more than one angle. The viewing angle cannot be changed when the DVD disc being played was not recorded with more than one angle. You are attempting to switch the angle in a DVD section where there is only one angle recorded. More than one viewing angle may be recorded only in limited sections in a DVD disc.