Information, Programming Guide and Support for the Code Alarm CATX1B Transmitter

Programming the Code Alarm CATX1B Transmitter
	CATX1B Programming Guide
	Warranty Card
	Register Product
	Required Battery:              CR2016 To replace the battery on the CATX1B There are small screws on the back of the case. Remove them to reveal the battery compartment.
Transmitter Programming: To reprogram the remote transmitter please perform the steps below: Turn the ignition ON. Press and hold the valet/override button. Within 10 seconds the system will chirp (3) three times. Press 1 button of each transmitter you wish to program. The system will respond with 1 light flash for each accepted transmitter. Pressing the override button at anytime during programming will advance to the next bank. NOTES: The system will exit transmitter programming after 15 seconds of inactivity. This system has 1 button programming which programs all channels of the system. The system will hold up to 4 transmitters in memory, programming a 5th transmitter will erase the oldest transmitter in memory.