Operating the Code Alarm CA425 Remote Start System

Operating the Code Alarm CA425 Remote Start Upgrade

SECURITY OPERATION

Press LOCK once:

• Doors lock.
• Courtesy lights (if on) shut off.
• Unit checks to see if doors, hood or trunk are open. If open, siren (or horn) sounds once, parking lights flash once, and system enters pre-arm mode.

Pre-arm mode:

• The unit will wait for the open door, hood or trunk to be closed. The LED is solid during pre-arm.
• If the entrance is secured, the siren/horn will sound again, parking lights will flash once, and the system will arm.
• If the entrance is not secured after 4 minutes, the siren/horn will sound again, parking lights will flash once, the system will arm, and the defective trigger or entrance will be ignored.

Note: If entrance is secured after 4 minutes, the system will immediately begin to monitor the entrance for intrusion.

If the above conditions are not present:

• Vehicle starter is disabled.
• Siren (or horn) sounds twice / parking lights flash twice.
• LED (Blue light) flashes slowly for duration of arm cycle.
• After 5 seconds, unit monitors all entrances and sensors.

If door, sensor, hood/trunk or ignition input is triggered:

• Siren/horn sounds for 30 seconds or until UNLOCK is pressed.
• Parking lights flash
• If the alarm system is triggered, pressing DISARM (once) will end the 30-second cycle.

The LED flashes a number of times to indicate which input triggered the alarm:

Number of flashes:

1. Interior Theft Sensor (Shock Sensor)
2. Hood/Trunk input
3. Door Input

Press DISARM:

• Doors unlock
• Factory alarm (if equipped) is turned off.
• Siren/horn sounds once/ parking lights flash once.
• Courtesy lights turn on for 30 seconds, or until ARM is pressed or ignition is turned on.
• Vehicle starter is enabled.

Press DISARM twice: Passenger doors unlock if using 2-stage unlock.

Press FIND: Siren/horn sounds 5 times.

Press and hold PANIC for 2 seconds: Siren/horn sounds and lights flash for 30 seconds or until any remote control button is pressed.

Press and hold TRUNK: Trunk or hatch opens, or other device activates.

If Ignition Lock option is set to On: Doors lock when all doors are closed and key is turned to ON position.

If Ignition Unlock option is set to On: Doors unlock when ignition is turned off.

REMOTE START OPERATION (If Equipped)

Press then press START button twice within 2 seconds. (single press start is selectable):

• Unit will flash 7 times if tach is not yet learned.
• Unit will flash 4 times if the remote start safety switch is not installed.

If the above conditions are not present:

• Parking lights flash once.
• Factory alarm (if equipped) is turned off.
• Factory VATS or PATS systems (if equipped) are interfaced (active output is activated).
• Interior Sensor is disabled.
• Vehicle ignition turns on.
• Heater/AC are powered.
• Vehicle starter begins to crank (heater/AC power shuts off while vehicle star ter is cranking).
• Vehicle successfully starts.
• Vehicle will shut off if hood is opened, brake is pressed, or if engine reaches 3 times its idle speed (Tach Sense Mode only).
• Parking lights stay on (or flash if selected) for duration of run time.
• Heater/AC is powered for duration of run time.

TRANSMITTER PROGRAMMING

Transmitter Programming (3 Chirps):

1. With the door open turn the ignition ON
2. Press and Hold the valet/override button.
3. Within 10 Seconds the system will chirp (3) three times.
4. Press Button 1 of each transmitter you wish to program.
5. The system will respond with 1 chirp for each accepted transmitter. Pressing the override button at anytime during programming will advance to the next bank.

Note: This system has 1 button programming which programs all channels of the system.

Thank you for your inquiry - Audiovox values our customers and though this product is no longer in production nor does it qualifiy for warranty or repair due to the age of the product, limited support information may be available through our FAQ Database and/or Customer Service.

Before you proceed check this and other answers related to your product by searching with the Model Number of your product from the Search Box above.

NOTE: Technical support, parts, user manuals (not shown on this FAQ), accessories, or repairs are either limited or NOT available for discontinued models