Connecting the RCA ANT700R Digital Amplified Antenna to your TV

Connecting the RCA ANT700R Digital Amplified Antenna to your TV
Connecting to Your TV Run the coaxial cable from the antenna towards your television set. Connect the coaxial cable to the ANT jack on the supplied amplifier insert. Connect built-in coaxial cable on the amplifier insert to the antenna input jack on your TV or converter box. Note: If you want to split the signal coming from the antenna, connect the short coaxial cable built into the amplifier insert to your splitter (splitter sold separately). DO NOT PUT THE SIGNAL SPLITTER BETWEEN THE AMPLIFIER INSERT AND THE ANTENNA. After all other connections are made, connect the power adapter into the amplifier insert. Plug it into a standard AC outlet. Important: This power adapter should be plugged in so that it stays vertical or lays flat. The amplifier insert should always be located indoors.
Water Damage Prevention At the point where your coaxial cable lead enters the house, you should allow for some slack in the coaxial cable as a “drip loop.” This will prevent moisture from running down the coaxial cable and entering the house. Run the coaxial cable approximately six inches below the wall entry point and then turn it upwards towards this spot. Any moisture that accumulates on the coaxial cable will drip off in the bend instead of running into the house. You should seal the point where the cable enters your home with a rubber weather insulator or silicone caulking (not included). An “F” connector wall plate can be used inside the home to cover the inside portion of the hole. You can typically find an “F” connector wall plate at any local electronics or hardware store.