Operating Instructions for the Jensen JKRS1 Remote Start System

Operating the Jensen JKRS1 Remote Start System

REMOTE STARTING THE VEHICLE: 

This unit will not start the vehicle if any one of the following situations exists:

• The vehicle's hood lid is opened.
• The gear shift selector is not in Park.
• The brake pedal is depressed.
• The safety control switch is in the Off position.

To start the vehicle:

1. Press and release the Key/Option button two times within 2 seconds. The vehicle will start and remain running for the pre-programmed 5,10,15,20 minute run cycle. As a visual indication, the parking lights will flash or remain on depending on the setting by your installation center.
2. When you arrive at the vehicle, turn the ignition key to the ON position (not the spring loaded start position), then step on the brake pedal to disengage the remote starter. The vehicle will continue to run, but now on it's own power.

NOTE: The engine will stop running before the pre-programmed run cycle has expired if you perform any one of the following functions:

• Press and release button 2 on the keychain transmitter two times within 2 seconds.
• Depress the brake pedal.
• Open the vehicle's hood
• Move the safety control switch to the Off position.

SAFETY CONTROL SWITCH: The red handle control switch allows you to temporarily disable the remote starting function of the system and moving this switch to the Off position is recommended whenever the vehicle is being serviced. When the system is disabled, the remote door locks and optional accessories will remain operational.