Operating Instructions for the Pursuit PRO9056TW Remote Start System

Operating the Pursuit PRO9056TW Remote Start System
Remote Starting the Vehicle	The system will not start the vehicle if any one of the following situations exists: The vehicle's hood lid is opened. The gear shift selector is not in Park.  The brake pedal is depressed. The safety control switch is in the Off position. To start the vehicle: Press and release the transmitter button two times within 2 seconds. The vehicle will start and remain running for the pre-programmed 5, 10, 15 or 20 minute run cycle. As a visual indication, the parking lights will flash or remain on depending on the setting by your installation center. When you arrive at the vehicle, turn the ignition key to the ON position (not the spring loaded start position), then step on the brake pedal to disengage the remote starter. The vehicle will continue to run, but now on it's own power. NOTE: The engine will stop running before the pre-programmed run cycle has expired if you perform any one of the following functions: Press and release button 2 on the key chain transmitter two times within 2 seconds. Depress the brake pedal. Open the vehicle's hood Place the unit in the safety control disabled mode.
Push-Button LED Receiver Valet/Override/Safety Control Switch	The Push-Button LED switch located in the receiver allows you to temporarily disable the remote starting function of the system. This recommended whenever the vehicle is being serviced. To place the system in the service mode: With the system disarmed/unlocked, and the ignition switch off, Press and Hold the Push-Button switch found on the windshield receiver, in. Turn the ignition switch on, off, on, off, on, off. The Orange LED begins to flash two short flashes followed by one long flash and continues this pattern until the unit is returned to the normal mode of operation. The above action puts the unit into the Remote Start Override/Service mode and will not start from the RF transmitter or any other input, Posse or otherwise. To Exit Remote Start Override Mode: With the system disarmed, Press and Hold the Push-Button switch found on the windshield receiver, in. Turn the ignition switch on, off, on, off, on, off. The LED turns off indicating that the Remote Start unit is fully functional once again.
Unlocking the Vehicle	If you have electric door lock, and the Optional Unlock feature was added, with the vehicle running under command of the remote start unit, press and hold the transmitter button for 3 seconds until the doors unlock.
Telematic Upgrade	This system has the ability to have a telematic upgrade module connected to it. This is an upgrade that can give you control of certain functions of your vehicle from a Telephone, or in some cases a computer interface. Please check with your installation center for most recent Telematic Upgrades. If you had a Telematic Upgrade installed, the manual supplied with the upgrade unit will provide a operators manual advising of the features of the system and means available to control these features of your vehicle.