Operating Instructions for PRO9256 Remote Start System

Operating Instructions for PRO9256 Remote Start System

Remote Starting the Vehicle

Note: The vehicle will not start if any one of the following situations exist: 

• The vehicle's hood lid is opened.
• The gear shift selector is not in Park.
• The brake pedal is depressed.
• The safety control switch is in the Off position.

To start the vehicle with your PRO9256:

1. Press and release the one way transmitter or two way transceiver button two times within 2 seconds. The vehicle will start and remain running for the pre-programmed 5,10,15, or 20 minute run cycle.
2. As a visual indication, the parking lights will flash or remain on depending on the setting by your installation center. If you operated the two way transceiver, the Blue Ring around the transceiver button will flash to confirm that the vehicle has started and will remain flashing once every few seconds to confirm that the vehicle is still running.
3. Once the vehicle is turned off, times out, or is entered and driven, the Blue Ring around the transceiver button will turn off.
4. When you arrive at the vehicle, turn the ignition key to the ON position (not the spring loaded start position), then step on the brake pedal to disengage the remote starter. The vehicle will continue to run, but now on it's own power.

Note: The engine will stop running before the pre-programmed run cycle has expired if you perform any one of the following functions:

• Press and the button on the key chain transmitter two times within 2 seconds.
• Depress the brake pedal.
• Open the vehicle's hood.
• Place the unit in the safety control disabled mode.

PBLED Safety Control Switch

The push-button LED control switch allows you to temporarily disable the remote starting function of the system. This is recommended whenever the vehicle is being serviced.

To place the system in the service mode:

1. With the system disarmed/unlocked and the ignition switch off, press and hold the PRLED on.
2. Turn the ignition switch on, off, on, off, on, off.
3. The LED begins to flash two short flashes followed by one long flashes and continues this pattern until returned to normal mode of operation. This puts the unit into the R/S Override mode indicating that the remote start is in the service mode and will not start from RF or any other input.

To Exit R/S Override Mode with the system disarmed:

1. Press and Hold the PRLED on.
2. Turn the ignition switch on, off, on, off, on, off.
3. The LED turns off indicating that the R/S unit is fully functional once again.

Unlocking the Vehicle

The unlock feature is optionally enabled at the dealer/installer.

If you have electric door lock, and the Optional Unlock feature was added at the dealer/installer, with the vehicle running under the command of the remote start unit, press and hold the transmitter/transceiver button for 3 seconds until the doors unlock.

<p style="FONT-WEIGHT: bold; TEXT-DECORATION: underline"