|
Operating the Code Alarm CA230 Security System |
|
Keyless Entry Locking the Vehicle Doors: To lock the doors, exit the vehicle, close all doors, then press the LOCK button. The status indicator (red warning light on the dash) will blink steadily, once per second, if equipped. Starter Disable (if equipped) will activate when the status indicator begins to blink. Unlocking the Vehicle Doors: To unlock the vehicle’s doors, press the UNLOCK button. The horn will “honk” and the parking lights will flash once, and the doors will unlock. The Starter Disable (if equipped) will disengage. Using the Progressive Car Finder Feature: Press the FIND/PANIC button on the remote control to locate your vehicle. The horn will emit five short “honks” at low volume, increasing in volume each of three times the button is pressed. Personal Protection Alarm (Panic): Press and hold the FIND/PANIC button to activate the vehicle horn and parking lights for 30 seconds. (If the vehicle horn is connected, the horn will “honk” a random pattern for 30 seconds.) Press any remote control button to turn off the “Personal Protection Alarm”. |
|
Using Valet/Service Mode Valet/Service Mode: You can turn off the starter disable feature by engaging the Valet/ Service Mode:
|
|
Emergency Disarm Procedure If your remote control is lost or fails to function, use this procedure to disarm the Code Alarm CA230 and start your vehicle.
|
|
System Maintenance This section outlines some of the basic issues you may experience Changing the Remote Control Battery: The 12-volt alkaline battery(GP-23A) supplied in your remote control should last approximately one year, depending on usage. When the battery begins to weaken, you will notice a decrease in range, or the distance from your vehicle that your remote transmitter will operate. Follow the instructions below to change the remote transmitter battery.
|
Comments
0 comments
Article is closed for comments.