Operating the Code Alarm PC4300 or ELITE4300 Security System

Operating the Code Alarm PC4300 or ELITE4300 Security System

Using Your Remote Transmitter

Arming the Security System: To arm the system, exit the vehicle, close all doors, then press the ARM button. The siren will “chirp” twice† and the parking lights will flash twice, indicating the system is armed. The doors will also lock at this time (if equipped and connected). The status indicator (red warning light on the dash) will blink steadily, once per second.

Pre-arm Mode: If the siren chirps and the parking lights flash only once, this indicates that the vehicle courtesy light is on, or that an entrance is not closed securely. Check to see that doors, hood, and trunk are properly closed. Once all entrances are secured (and the courtesy light is off), the system will chirp / flash again. The system is now fully armed. (If the entrance is not secured within 4 minutes, the system will arm and ignore the unsecured entrance until it is closed.)

Disarming the Security System: To disarm the system, press the DISARM button. The siren will chirp and the parking lights will flash once, and the doors will unlock. The courtesy light will turn on and the LED will flash GRN for 1 minute, or until the vehicle is started.

Attempted Intrusion Identification: If the siren chirps four times when disarming, this indicates that the system was triggered in your absence. The status indicator will also flash rapidly. Perform the following operation to determine the protected zone that triggered the system: After disarming, press the emergency override button. The siren will chirp to indicate the cause of the alarm trigger: 1 chirp IT-s Interior Theft Sensor. 2 chirps Door. 3 chirps Hood. 4 chirps Trunk/Optional Sensors. 5 chirps Ignition was turned on.

Disabling the IT-s Interior Theft Sensor: It may be necessary at times to disable the IT-s Interior Theft Sensor, especially when parking in areas (like parking garages) where extreme vibration may cause false alarms. Press the ARM button and then press the FIND/PANIC button within two seconds of pressing ARM to disable the interior theft sensor. The siren will chirp three times to indicate that the sensor is disabled. The sensor will become enabled again the next time the system is armed normally.

Two-Stage Door Unlock: If this feature is enabled on your system, pressing DISARM one time will unlock only the driver’s door. Press DISARM again within 1 minute to unlock all doors.

Activating the Trunk Release Feature: Press and hold TRUNK to open the vehicle trunk or hatch (if equipped and connected). If this button is used to operate another accessory, the accessory will stay active for as long as the button is held.

Turning on the Vehicle Headlights: Press and hold the LIGHTS button to turn on the vehicle headlights. (The alarm system will attempt to arm if not already armed, unless it is in Valet mode.) The lights will stay on for 20 seconds, or until LIGHTS is pressed again.

Using AUX 3: If this feature is enabled on your system, pressing AUX for 1 second will activate the auxiliary function (if enabled).

Using the Progressive Car Finder Feature: Press FIND on the remote control to locate your vehicle. The