Operating the Code Alarm PC5100 Keyless Entry Upgrade

Operating the Code Alarm PC5100 Keyless Entry Upgrade

Using Your Remote Transmitter

Arming the Security System: To arm the system, exit the vehicle, close all doors, then press the LOCK button on your OEM Keyless Entry Remote Control. The siren will “chirp” twice and the parking lights will flash twice, indicating the system is armed. The status indicator (red warning light on the dash) will blink steadily, once per second.

Pre-arm Mode: If the siren chirps and the parking lights flash only once, this indicates that the vehicle courtesy light is on, or that an entrance is not closed securely. Check to see that doors, hood, and trunk are properly closed. Once all entrances are secured (and the courtesy light is off), the system will chirp / flash again. The system is now fully armed. (If the entrance is not secured within 4 minutes, the system will arm and ignore the unsecured entrance until it is closed.)

Disarming the Security System: To disarm the system, press the UNLOCK button on your OEM Keyless Entry Remote Control. The siren will chirp and the parking lights will flash once.

Attempted Intrusion Identification: If the siren chirps four times when disarming, this indicates that the system was triggered in your absence. The status indicator will also flash rapidly. Perform the following operation to determine the protected zone that triggered the system: After disarming, press the emergency override button. The siren will chirp to indicate the cause of the alarm trigger: 1 chirp IT-s Interior Theft Sensor. 2 chirps Door. 3 chirps Hood. 4 chirps Trunk/Optional Sensors. 5 chirps Ignition was turned on.

Using Aux 1: If this feature is enabled on your system, pressing LOCK (on your OEM Keyless Entry Remote Control) 2 times within 3 seconds will activate this function.

Using Aux 2: If this feature is enabled on your system, pressing UNLOCK (on your OEM Keyless Entry Remote Control) 2 times within 3 seconds will activate this function.

To enter valet mode: With the key, turn the ignition on, then turn off 3 times within 5 seconds.

To exit Valet mode: With the key, turn the ignition on, then turn off 3 times within 5 seconds.

Disarming Using Trunk Pop: If your OEM Keyless Entry Remote Control is equipped with a remote trunk opener, pressing the TRUNK button will disarm the vehicle security system. This will allow you to enter the trunk without triggering the security system.

When Your Security System is Triggered

The PowerCode PC 5100 will trigger if one of the following events occurs while the system is armed:

• Any protected entrance is opened
• The vehicle ignition is turned on
• The vehicle is jolted hard enough to signal the impact detector

Once the alarm is triggered, the siren (or horn) sounds and the vehicle parking lights flash for 30 seconds. The system will then rearm, awaiting the next intrusion attempt.

To stop the siren while keeping the alarm armed and doors locked: press the LOCK button (on the OEM Keyless Entry Remote) while the system is triggered.

<p style="FONT-WEIGHT: bold; TEXT-DECORATION: