|
Remote Operation for the Code Alarm CA2051 Keyless Entry System |
|
|
Using Your Remote Control Locking the Vehicle: To lock the vehicle, exit the vehicle, close all doors, then press the Lock button. The parking lights will flash 2 times, indicating the system has locked the doors and activated the starter interrupt feature (if equipped and connected). The LED status indicator will blink steadily, once per second.
Unlocking the Vehicle: To unlock the vehicle press the Unlock button. The parking lights will flash 1 time, indicating the system has unlocked the doors and disabled the starter interrupt feature (if equipped and connected).
Two Stage Door Unlock (Optional): If this feature is enabled on your system, pressing the Unlock button one time will unlock only the driver’s door. Press Unlock again within three seconds to unlock the remaining doors. Eliminating Lock / Unlock Notification Chirps: System lock and unlock notification chirps can be toggled ON or OFF without entering the programming feature banks.
Valet Mode: When valet mode is activated the status LED will light solid, and all security functions will be disabled. To enter or exit valet mode simply follow the 4 steps outlined below:
Activating the Trunk Release Feature (Optional): If this feature is enabled on your system, pressing and holding the Trunk button for 3 seconds will open the vehicle’s trunk or hatch. Using the Progressive Car Finder Feature: Press the Alarm button to locate your vehicle. The system will sound 5 times at low volume, increasing in volume each time the button is pressed. Using the Personal Protection Alarm (Panic): Press and hold the Alarm button for 3 seconds to activate the personal protection alarm. During panic mode, the normal function of the transmitter buttons will be suspended. The transmitter’s Lock and Unlock buttons can be used to lock and unlock the door (if the option is installed). To stop the alarm, press and hold the Alarm button on the transmitter again for 3 seconds. The system will automatically stop after 30 seconds. |
|
|
LED, Horn and Parking Light Indications
|
|
|
Transmitter Button Functions
|
|
|
Replacing Remote Control Batteries 1-Way Remote Control: The batteries (model CR2016) inside each remote control should last approximately 1 year under normal use. When the batteries become weak you will notice the remote control range (the distance from the vehicle the remote control will work) deteriorate and the small LED on the remote control will dim. To replace the remote control batteries:
|


Comments
0 comments
Article is closed for comments.