Articles in this section

See more

Operating Instructions for PRO9801A Remote Start Security System

Avatar
CS
Updated
Follow

 

Operating Instructions for the Pursuit PRO9801A Remote Security System
Arming the System - Active:
  1. Turn off the engine, exit the vehicle, and close all doors, hood lid and trunk lid.
  2. Press and release Lock/Arm button on the keychain transmitter.
    • The dash mounted LED begins to flash slowly. 
    • Parking Lights flash one time.
    • Siren sounds one chirp.
      If the siren/horn sounds 3 chirps, then you have left a door, trunk, or hood lid ajar. Simply close the opened entry point to provide full protection. If the siren "chirped" three times, sometime after arming, the exclusive delayed dome light learn circuit has been programmed and the system detected a open entry point after the learned delay expired. Again, closing the hood, trunk, or doors will correct the problem and you do not need to disarm the system to make the correction. If the siren/ horn did not sound when arming, then the chirps have been turned off and you should refer to the section titled "ELIMINATING THE ARM/DISARM CHIRPS" below.
    • Doors Lock - Optional

Note: If the optional Headlamp illumination feature has been added, and has been selected for operation when arming, as an added convenience, the system will turn on the headlights when the system is armed.
Silent Arming - Active:
  1. Turn off the engine, exit the vehicle and close all doors, hood lid and trunk lid.
  2. Press and hold the Lock/Arm button on the keychain transmitter for 2 seconds.
    • The dash mounted LED begins to flash slowly.
    • Parking Lights flash one time.
    • Siren will not sound.
      If the siren "chirped" three times, sometime after arming, the exclusive delayed dome light learn circuit has been programmed and the system detected a open entry point after the learned delay expired. Closing the hood, trunk, or doors will correct the problem and you do not need to disarm the system to make the correction.
    • Doors Lock - Optional

Note: If the optional Headlamp illumination feature has been added, and has been selected for operation when arming, as an added convenience, the system will turn on the headlights when the system is armed.
Arming the System - Passive (Automatic):

(Must be activated during programming)

  1. Turn off the engine, exit the vehicle and close and lock all doors, hood lid and trunk lid.
    • The dash mounted LED begins to flash rapidly, indicating 30 second passive arming has begun.
  2. Opening any protected entry point during the 30 second passive arming cycle will immediately suspend automatic arming and the 30 second passive arming cycle will re-start when all doors are closed. At the end of the passive arming cycle:
    • The dash mounted LED begins to flash slowly.
    • Parking Lights flash one time.
    • Siren sounds one chirp.
      If the siren did not sound when arming, then the chirps have been turned off and you should refer to the section titled “ELIMINATING THE ARM / DISARM CHIRPS“ below.
    • Doors Lock - Optional
      Door locking during passive arming is a selectable feature. The alarm can be programmed to allow the doors to lock only when arming using the keychain transmitter and they will not automatically lock

Comments

0 comments

Article is closed for comments.