Installation and Wiring Precautions on the Audiovox XMC10 or XMC10A Xpress Receiver Car Cradle

Installation and Wiring Precautions on the Audiovox XMC10 Xpress Receiver Car Cradle 

Cautions and Warnings   

1. Do not install the XMC10 car cradle in a position that hinders your view through the windshield, or obstructs viewing of the dashboard indicators and displays.

2. Do not install the unit where it may obstruct the operation or deployment of safety devices, such as airbags, etc.

3. Do not allow operation of the unit to detract from safe driving practices; remember that you are responsible as the vehicle operator to adhere to all safe driving and traffic regulations.

4. This unit complies with the interference limits relative to a Class B digital device, applicable under Part 15 of the FCC Rules regarding installation in a residential environment. If the unit is not installed in accordance with these instructions, it could cause harmful interference to radio or television reception. If this condition persists after corrective action, consult your dealer or experienced installation facility.

5. By adhering to these warnings and safety considerations, serious accidents and/or personal injury can be avoided.

Installation/Wiring Precautions

1. To prevent a short-circuit, be sure to turn off the ignition and remove the negative (-) battery cable prior to installation. Connect power wires last.

2. Do not install the unit in the locations exposed to direct sunlight or, in areas subject to extreme temperatures.

3. Incorrect installation may cause damage to the system. Mount the unit firmly in place, using the supplied hardware.

4. Be careful not to damage the vehicle wiring.

5. Be sure to use the supplied screws and washers.

6. Be careful not to snag any wires when tightening screws.

7. Use only the 12 Volt-to-5 Volt DC Power Adapter supplied. Use of an alternative power adapter may damage the Xpress XM® unit and/or the XMC10 cradle.

CAUTION: You could drain the vehicle battery if the DC power adapter remains plugged in after the ignition is turned off. Unplug the adapter to prevent this possibility.

You can access the Installation Guide Here.