Articles in this section

See more

Modes of Operation for the Jensen NVXM1000 XM Ready Navigation

Avatar
CS
Updated
Follow

Modes of Operation for the Jensen NVXM1000 XM Ready Navigation 

Getting Started
To initialize NVXM1000 operation, proceed as follows:    

a. Connect the adapter power cord to a power source (home, car adapter); then plug the adapter DC power connector into the DC connector on the right side of the unit.

b. If the XM® receiver is to be used, connect the XM antenna cable to the XM ANT connector on the rear left side of the unit.

c. Adjust the tilt, angle and horizontal position of the unit to suit your personal preference.

Note: If the unit is being turned on for the first time, or after a prolonged period of not being used, perform step d; otherwise, perform step e.

d. On the bottom of the unit, on the right side, position the power On/Off slide switch to the On position to initially turn on the unit; the JENSEN logo appears on the screen for about 10 seconds, after which the operational modes default display appears.

e. If the NVXM1000 was recently on and being used, and has been turned off (standby mode) using the Home button , pressing the Home button for 2 seconds again turns on the unit and the operational modes default display appears.

Image

Image

Implementing NVXM1000 Modes of Operation

The following sections present a description of each of the NVXM1000 operational modes and include
interconnect data when applicable.

A. Navigation Mode: To enable the Navigation mode of the NVXM1000, perform the following steps:

  1. Turn on power to the unit.
  2. When the operational modes default display appears, press the NAVIGATION icon on the LCD touch screen. A navigation warning screen will appear on the display followed by the Main Map Screen.
  3. Refer to NavMate Navigation Software User Manual, 128-7837, for a detailed description of navigation mode operation using the NVXM1000.

B. XM Ready Mode

1. Hardware and Subscription
To listen to XM satellite radio on the NVXM1000, the following optional items are required:

  • XM Mini-Tuner
  • XM antenna installed in your vehicle.
  • A subscription to XM® Satellite Radio.

2. Equipment Setup
Perform the following steps to prepare the NVXM1000 for XM® Radio operation:

a. Insert the Tuner into the Mini-XM Tuner slot at the left side of the unit; make sure the connectors mate easily and firmly without binding. If no tuner is installed, the following message appears on the display:

b. Plug the external XM antenna cable into the XM ANT jack at the rear of the unit and set the Power On/Off slide switch to the On position. If the antenna is faulty or improperly connected, the following message appears on the display:

3. Note Your ID Number

a. When the operational modes default display appears, press the XM READY toolbox button on the LCD touch screen; the XM READY logo appears for 10 seconds, followed by the XM default screen.

b. Select Channel 0 using the CH Up ( ) or Down ( ) buttons on the touch screen. The XM Mini tuner’s eight-digit XM Satellite Radio ID number will appear on the display. Write the number here:

4. Activate Your Satellite Radio Service

5. Online Activation Process: Once the ID code is obtained, log on to XM® at http://activate

Comments

0 comments

Article is closed for comments.