Installing the Audiovox CMOS2 Camera

Installing the Audiovox CMOS2 Camera

Installation Bumper Mounted 

Before you drill a hole on the rear bumper, you must check what is behind where you are drilling. If there are any vehicle components, such as electrical parts or fuel system components behind where you are drilling, you must take whatever precaution necessary not to damage them. Insure you have enough depth for the camera housing.

1. You will only need #2 attached to the camera.

2. Use a 15/16” diameter hole saw to drill a hole on the rear bumper.

3. Insert the camera cable into the hole and carefully feed through the hole. Route the cable into the trunk or Tail Light Housing area.

4. Connect the camera power cable: Red to reverse lamp power +12V and black to ground

5. Connect the monitor and camera using a video coax cable.

Note: DO NOT USE AN AUDIO RCA CABLE.

Traditional Drilled/Angled Mount

1. Parts # 3, 4, 5, &6 may be used depending on the mounting location selected. Use any combination to adjust to your required mounting angle.

2. Use a 15/16” diameter hole saw to drill a hole where you are mounting the camera.

3. Insert the camera cable into the hole and carefully feed through the hole. Route the cable into the trunk or Tail Light Housing area.

4. Connect the camera power cable: Red to reverse lamp power +12V and black to ground

5. Connect the monitor and camera using a video coax cable.

Note: DO NOT USE AN AUDIO RCA CABLE.

Long Butterfly Style Bracket

1. Parts #2, #1 #3, #7, #4, #5 and #6 May be used, The Butterfly mount can be at any position on the camera.

2. Mount the camera using two screws; always look before you screw into the vehicle to insure there is nothing located behind your mounting location.

3. Route the cable into the trunk or Tail Light Housing area.

4. Connect the camera power cable: Red to reverse lamp power +12V and black to ground

5. Connect the monitor and camera using a video coax cable.

Note: DO NOT USE AN AUDIO RCA CABLE.

Short butterfly style bracket

1. Parts #2, #1, #3, #4, #5, #8 and #6 May be used. The Butterfly mount can be at any position on the camera.

2. Mount the camera using two screws; always look before you screw into the vehicle to insure there is nothing located behind your mounting location.

3. Route the cable into the trunk or Tail Light Housing area.

4. Connect the camera power cable: Red to reverse lamp power +12V and black to ground

5. Connect the monitor and camera using a video coax cable.

Note: DO NOT USE AN AUDIO RCA CABLE. 

Surface Mounted Plastic bracket

1. Combine Parts #2, #1, #9, #2 and #6.

2. Mount the camera using two screws; always look before you screw into the vehicle to insure there is nothing located behind your mounting location.

3. Route the cable into the trunk or Tail Light Housing area.

4. Connect the camera power cable: Red to reverse lamp power +12V and black to ground

5. Connect the monitor and camera using a video coax cable.

Note: DO NOT USE AN AUDIO RCA CABLE.