Operating Instructions for Prestige APS255A Remote Alarm System

Operating Instructions for Prestige APS255A Remote Alarm System
Arming the System - Active:	Turn off the ignition, exit the vehicle, and close all doors, hood lid and trunk lid. Press and release the Arm/Lock button on the key chain transmitter one time.
Silent Arming - Active:	Turn off the engine, exit the vehicle and close all doors, hood lid and trunk lid. Press and hold the Arm/Lock button on the key chain transmitter for two seconds.
Arming the System - Passive (Automatic):	Turn the ignition key off, exit the vehicle, and close all doors. The LED will begin to flash rapidly, 30 seconds later the system is armed. Opening any protected entry point during the 30 second passive arming cycle will immediately suspend automatic arming and the 30 second passive arming cycle will re-start when all doors are closed. At the end of the passive arming cycle the LED begins to flash slowly, the parking lights flash one time, the siren/horn sounds one chirp and the door locks are optional. If the siren did not sound when arming, then the chirps have been turned off.
Protection while the system is armed:	Opening any protected door will cause the alarm to immediately sound. The alarm will continue to sound for 30 seconds, then stop and continue to monitor all protected entry points. If the thief left a door opened, the alarm will sound for six 30 second cycles, remain armed and ignore that triggered zone. Whenever the system is armed, the dash mounted LED will slowly flash. This serves as a visual deterrent to a potential thief. This LED is a very low current light emitting diode and will not cause the battery to drain even if left unattended for long periods of time. Whenever the system is triggered, the vehicle's parking lights will flash for the full 30 second alarm cycle, attracting visual attention to the vehicle. Whenever the system is armed, the vehicle's starting circuit will be bypassed. If the thief should choose to ignore the siren/horn, the vehicle cannot be started. Any strong impact the vehicle's glass will cause the alarm to trigger for the full 30 second alarm cycle. Any mild impact to the vehicle's glass will cause the alarm to sound a short series of warning tones.
Disarming the System:	Note: If the optional 2 step door unlock circuit is installed, when the unlock transmitter button is activated, the drivers door only will unlock, pressing the unlock button a second time will cause all doors to unlock. As you approach the vehicle, press and release the Disarm/Unlock button on the key chain transmitter.
Silent Disarming:	As you approach the vehicle, press and hold the Arm/Disarm button on the key chain transmitter for 2 seconds.
While the System is Sounding:	If during a triggered state, you wish to shut off the siren without disarming your security system, simply press and release any transmitter button other than the disarm button. This action will turn off the siren yet leave the vehicle fully armed and protected. In this case you can cancel the siren sounding without disarming your alarm.
Intrusion Warning Signals:	This system will inform you if an intrusion attempt has occurred while you were away from