Operating Instructions for AA929 Remote Alarm System

Operating Instructions for AA929 Remote Alarm System
Programming the Transmitters:	Your security system will learn up to two Audiovox code learning transmitters. To program these transmitters:  Disconnect power to the alarm for 10 seconds. Reconnect power. Within 10 seconds, press button #1 of the first transmitter to be programmed. Within 5 seconds of the first learn transmitter, press button #1 of the second transmitter to be programmed.
Arming the System:	Exit the vehicle, close all doors. Press button 1 one time. To arm without the shock sensor: Press the arm button twice within 3 seconds. The next normal arming of your system will reinstate the shock sensor.
Disarming the System:	As you approach the vehicle, press button 1 one time.
Testing the Voltage Sensor:	Arm the alarm system by pressing button 1 one time. Wait 4 seconds to allow the unit to stabilize. Open any light activated entry point, the siren will immediately trigger. Turn the alarm system off by pressing button 1 of a programmed transmitter one time. Repeat the above procedure for each light activated entry point.
Voltage Sensor Adjustment:	If your vehicle does not trigger when the door is opened and the interior light turns on, it may be necessary to increase the voltage sensor's level of detection. Before making this wiring change, confirm that the interior light is in good working order and illuminates when any door is opened. If your interior light works properly, and the unit does not trigger, the Red wire will have to connect to a +12 volt source closer to the interior light. This may necessitate moving the Red wire to the interior of the vehicle and connecting to the interior light fuse. Routing the Red wire through a firewall grommet and connecting to the interior light fuse may be beyond the scope of your automotive wiring experience. If you are uncertain of this procedure, consult your dealer or qualified mechanic before attempting to re-wire the voltage sensors through the firewall to increase the voltage sensor's level of detection.
Testing the Shock Sensor:	Note: The Shock Sensor incorporated in your security system operates on two levels in any sensitivity range. The warn away (pre-detect) stage operates at 30% less shock (vibration) than the full trigger stage. Arm your security system and allow the unit to stabilize. Strike the windshield support pillar with the palm of your hand, the unit will emit a few short chirps from the siren. This is the warn away (pre-detect) stage. Striking the support pillar firmly will cause the siren to sound. This is the full trigger stage. Repeat the above steps from various support areas of your vehicle; Bumpers, B Pillars, etc.
Shock Sensor Adjustment:	The Shock Sensor of your security system is electronically adjusted and is capable of 8 different sensitivity levels. To adjust or change the setting: Disarm the system. Within 8 seconds, simultaneously press both buttons of your transmitter until the siren emits a low tone. Press button