Operating Instructions for APS510A Alarm Security System

Operating Instructions for Prestige APS510A Alarm Security System
Arming the System - Active:	Turn off the ignition, exit the vehicle, and close all doors, hood lid and trunk lid. Press and release the Arm/Lock button on the key chain transmitter one time.
Silent Arming - Active:	Turn off the engine, exit the vehicle and close all doors, hood lid and trunk lid. Press and hold the Arm/Lock button on the key chain transmitter for two seconds.
Arming the System - Passive (Automatic):	Turn the ignition key off, exit the vehicle, and close all doors, hood lid, and trunk lid. The LED will begin to flash rapidly, 30 seconds later the system is armed. Opening any protected entry point during the 30 second passive arming cycle will immediately suspend automatic arming and the 30 second passive arming cycle will re-start when all doors are closed.
Protection while the system is armed:	Opening any protected door, hood, or trunk lid will cause the alarm to immediately sound. The alarm will continue to sound for 30 seconds, then stop and continue to monitor all protected entry points. If the thief left a door opened, the alarm will sound for six 30 second cycles, remain armed and ignore that triggered zone. Whenever the system is armed, the dash mounted LED will slowly flash. This serves as a visual deterrent to a potential thief. This LED is a very low current light emitting diode and will not drain the battery even if left unattended for long periods of time. Whenever the system is triggered, the vehicle's parking lights will flash for the full 30 second alarm cycle, attracting visual attention to the vehicle. Any strong impact to the vehicle's glass will cause the alarm to trigger for the full 30 second alarm cycle. Any mild impact to the vehicle's glass will cause the alarm to sound a short series of warning tones.
Disarming the System:	As you approach the vehicle, press and release the Disarm/Unlock button on the key chain transmitter.
While the System is Sounding:	If during a triggered state, you wish to shut off the siren without disarming your security system, simply press and release any transmitter button other than the disarm button. This action will turn off the siren yet leave the vehicle fully armed and protected.
Silent Disarming:	As you approach the vehicle, press and hold the Arm/Disarm button on the key chain transmitter for 2 seconds.
Intrusion Warning Signals:	This system will inform you if an intrusion attempt has occurred while you were away from the vehicle. If an intrusion attempt has occurred, the siren/horn will chirp 4 times and the parking lights will flash 3 times when disarming the system. Enter the vehicle, and observe the dash mounted LED to identify which zone was triggered. If the LED is flashing one time...pause...one time...pause, etc. then an intrusion attempt was made to the shock sensor, or an accessory triggering device that may have been added to the system. If the LED is flashing two times...pause...two times...pause, etc. then an intrusion attempt was made to a hood or trunk pin switch that was added to the system, or to a light activated entry point if the alarm was installed using the voltage sensing feature. If the LED is flashing three times...