Operating Instructions for APS57N Remote Start System

Operating Instructions for Prestige APS57N Remote Start Systems
Keyless Entry:	To lock or unlock the doors simply press and release button 1 one time. As a keyless entry unit, for your convenience, the parking lights will flash once when the doors are locked and twice when the doors are unlocked.
Remote Car Finder:	To access the car finder mode, while within range of your car, simply press and hold either the lock or unlock button of your transmitter for three seconds. The parking lights will begin to flash making your vehicle more visible. The lights will stop automatically after 30 seconds. If you wish to turn off the car finder mode prior to the expiration of the 30 second timer, press and release either the lock or unlock button of your transmitter one time.
Remote Trunk Release:	If you have electric trunk release in your vehicle and the remote trunk release option was added to your vehicle, simply press and hold the Key/Trunk button of your transmitter for 4 seconds or until the electric trunk of your vehicle opens.
Remote Starting the Vehicle:	The system will not start the vehicle if any of the following situations exists: The vehicle's hood lid is open. The gear shift selector is not in park. The brake pedal id depressed. The safety control switch is in the off position. To start the vehicle: Press and release the Key/Trunk button two times within 2 seconds. The vehicle will start and remain running for the pre-programmed 5, 10, 15, 20 minute run cycle. As a visual indication, the parking lights will flash or remain on depending on the setting by your installation center. When you arrive at the vehicle, turn the ignition key to the On position (not the spring loaded start position), then step on the brake pedal to disengage the remote starter. The vehicle will continue to run, but now on its own power.
PRLED Safety Control Switch:	The Push-Button LED control switch allows you to temporarily disable the remote starting function of the system. This is recommended whenever the vehicle is being serviced. To place the system in the service mode: With the system disarmed/unlocked, and the ignition switch off, press and hold the PRLED on. Turn the ignition switch on, off, on, off, on, off. The LED begins to flash two short flashes followed by one long flash and continues this pattern until returned to normal mode of operation. This puts the unit into the R/S Override mode indicating that the remote start is in the service mode and will not start from RF or any other input, Posse or otherwise. To exit R/S Override mode: With the system disarmed, press and hold the PRLED on. Turn the ignition switch on, off, on, off, on, off. The LED turns off indicating that the R/S unit is fully functional once again.

For more detailed operating instructions, please refer to your
Owner's Manual.