Programming the PS195BT3

To program the PSI95BT3 it is important to note that all steps must be made within 15 seconds of the previous step.  

1. To program the PSI95BT3 first enter the vehicle and turn the ignition key to the on position.
2. Move the valet switch on, off, on, off, on, and off again.
3. The dash LED light will flash once and the siren will chirp once indicating the system is ready to program the new transmitter.
4. You can then assign any of the 3 buttons to channel 1 by pressing and hold it until the siren emit one long chirp.
5. Move the Valet switch on and off again.
6. The LED will flash 2 time and the siren will chirp once indicating the system if ready to program channel 2.
7. At this point assign any of the remaining 2 key by pressing and holding it until the siren emits one long chirp.
8. Move the valet switch on and off again.
9. The LED will flash 3 time and the siren will chirp once indicating the system is ready to program channel 3.
10. Press and hold the remaining key and the siren will emit one long chirp and you are finished programming the transmitter.
11. Now you must exit the program mode by either turning the ignition key to the off position or by switching the valet switch on the off again and the siren will emit one long chirp as confirmation of exiting the program mode.