Troubleshooting the Advent AW870 Wireless Speaker System

Troubleshooting the Advent AW870 Wireless Speaker System
Problem:	Solution:
Why isn't there any sound coming from the AW870 speakers?	Confirm that the Transmitter AC Adapter (0) is inserted into the wall outlet and the power cord from the AC adapter is firmly connected to the Transmitter Power Input Jack (I). Confirm that the speaker is turned “ON”. Confirm that the Speaker AC Adapter(P) is fully inserted into the wall outlet and the power cord from the AC adapter is firmly connected to the Speaker Power Input Jack (F). Check that the “C” cell batteries are fresh and inserted for correct polarity (+, -). Check that the audio source (stereo, TV, etc.) is turned on and providing sound as it normally should. Check that the speaker volume (D) is turned up. If you are using a Tape 2 Monitor output from your receiver/amp as the audio output, check that you have pressed the Tape Monitor/Tape 2 button on the front of the receiver. This will turn on the Tape 2 outputs, which may be inactive otherwise.
Why is there sound in only one of the AW870 speakers?	Check the left/right balance control on the audio source.
Why is the sound coming from the AW870 speakers distorted or why does the audio contain static?	If using battery power, batteries may be low. Replace if necessary. Check that the speaker Tuning Indicator Light (A) is illuminated green. If not, adjust the Tuning Control Wheel (B) until the light changes from red to green. Check that the transmitter Audio Level Indicator Light(H) is flickering intermittently. If you are using a fixed output and the tight is on solid, or if the light is not on at all, adjust the Output Level Control Wheel (K) so that the light flickers intermittently. If you are using a variable output, make sure the Output Level Control Wheel (K) is all the way right (as shown under “Adjust the Transmitter” page 7) and adjust the volume on the audio source up or down as necessary to make the tight flicker intermittently. Change the position of the transmitter Frequency Control Wheel (N) to change the operating frequency. Then, readjust the speaker Tuning Control Wheel (B) until Tuning Indicator Light (A) changes color to green. Try changing the physical location of the transmitter. Locate it as high and free of obstruction as possible. Avoid placing directly on top of a TV, if possible. Try moving the transmitter and speakers closer together. Sending the signal through certain materials, such as glass, tile, and metal, can decrease the effective transmitting distance of the system.