Setup and Installation of the Audiovox SIRBB1 Satellite Shuttle Boom Box

Setup and Installation of the Audiovox SIRBB1 Satellite Shuttle Boom Box

Installation/Wiring Precautions 

1. If using the adapter, make sure the adapter cable is not connected to an AC wall outlet until all interconnections have been made and verified. The adapter power cable should be connected last.
2. Incorrect installation may cause damage to the system.
3. During antenna placement/installation, refer to the Antenna Aiming procedure outlined in the Shuttle User Guides, SIR-PNP1(1286812) or SIR-PNP2 (1286901).

Setting Up and Installing Your Kit

NOTE: The SIRIUS® signal can be received and processed virtually anywhere as long as there are no obvious satellite signal obstructions such as high terrain, trees, overhangs, etc. However, signal reception depends mainly on where you are, geographically, and where this place is with respect to the orbital paths of the Sirius satellites. In placing the antenna, therefore, these factors must be taken into account.

1. Turn the Boom Box upside down to access the battery compartment.
2. Push the battery cover latches forward and flip up the battery compartment cover to the open position.
3. Insert eight (8) D-Cell batteries observing battery polarity as shown; then close the cover.
    

Cabling Interconnections: You can begin to enjoy Sirius® Satellite Radio as soon as the Shuttle and Boom Box Kit installation are complete. Set up your Audiovox SIR-BB1 by following the interconnect diagram.

Installing the Shuttle in the SIR-BB1: Place the Shuttle in the cradle so that the Shuttle guides are lined up with the SIR-BB1 cradle. Then push the Shuttle forward to engage the connectors. The Shuttle will snap into place. Apply power to the SIR-BB1 by rotating the VOL control clockwise from the off position; the LED indicator lights green. If the Shuttle does not turn on at the same time, press the red Power On/Off button in the upper left corner of the Shuttle front panel.

Removing the Shuttle From the SIR-BB1: Press and hold the eject button on top of the Boom Box; the Shuttle will partially eject forward. Using your thumb and forefinger, grasp the Shuttle on the sides and pull forward to disengage.

Interconnect Diagram:

Installing/Positioning the Antenna: For best reception, the supplied antenna should be placed near a window if in the house or, if outdoors, in an open area and as high as possible; some repositioning may be required to achieve optimum results. The following guidelines are recommended:

1. In a major city, where Sirius ground repeaters are present, you can usually place the antenna away from a window and still achieve the desired results.
2. You can also place the antenna outside (on the roof structure), provided it is clear of any overhead obstructions. Because of the orbiting characteristics of the Sirius Satellite