Programming the Prestige APS95BT3 Transmitter

Programming the Prestige APS95BT3 Transmitter

The transmitters included with the security system have been pre - programmed at the factory, with each button pre - assigned to control a specific function of the security system. Although the security system in the vehicle has either 3 or 4 channels (RECEIVER) depending on the model, the transmitters included with the system are 7 channel transmitters. This allows you to program each transmitter to more than one vehicle in two car families, and also allows you to change which button(s) control certain functions of the system. (Example: Transmitter channel 5 can be programmed to activate Receiver channel 2.) Refer to the chart below for access to each of the transmitter channels, and for the standard factory button assignments. 

PROGRAMMING THE TRANSMITTERS

It is important to remember that during programming, each individual step of the procedure must be executed within 15 seconds of the previous step. When the 15 second time limit is allowed to expire, the system will automatically terminate the programming mode. This is indicated by a long chirp from the siren. Additionally, the system will store codes from up to four different transmitters. If a 5th transmitter is programmed to any receiver channel, then the first transmitter programmed to that channel will be erased from the system's memory.

To program new or additional transmitters:

1. Enter the vehicle, and turn the ignition key to the " on " position.
2. Flip the valet switch on - off - on - off - on - then off.
3. The dash LED will flash one time, and the siren will chirp one time, indicating the system is ready to accept programming for receiver channel 1.
4. Press and hold the selected transmitter button(s) until the siren sounds a long chirp, indicating the signal has been stored into memory.
5. If you have additional transmitters (up to 3) that need to be programmed, repeat step 4 for each transmitter.
6. Flip the valet switch on then off.
7. The dash LED will flash two times, and the siren will chirp two times, indicating the system is ready to accept programming for receiver channel 2.
8. Press and hold the selected transmitter button(s) until the siren sounds a long chirp, indicating the signal has been stored into memory.
9. If you have additional transmitters (up to 3) that need to be programmed, repeat step 8 for each transmitter.
10. Flip the valet switch on then off.
11. The dash LED will flash three times, and the siren will chirp three times, indicating the system is ready to accept programming for receiver channel 3.
12. Press and hold the selected transmitter button(s) until the siren sounds a long chirp, indicating the signal has been stored into memory.
13. If you have additional transmitters (up to 3) that need to be programmed, repeat step 12 for each transmitter.
14. Flip the valet switch on then off.
15. The dash LED will flash four times, and the siren will chirp four times, indicating the system is ready to accept programming for receiver channel 4.
16. Press and hold the selected transmitter button(s) until the siren sounds a long chirp, indicating the signal has been stored into memory.
17. If you have additional transmitters (up to 3) that need to be programmed, repeat step 16 for each transmitter.
18. Turn the ignition key off. The siren will sound one short chirp then one long chirp indicating the system terminated the program mode.

Required Battery:

• GP23A