Narrowband and Wideband Tuning Positions for the TERK AF1 Antenna

Narrowband and Wideband Tuning Positions for the TERK AF1 Antenna

AM/ FM Wideband Tuning Position

To set the antenna to wideband mode rotate the bottom dial clockwise until all LEDs are red. Wideband mode disables the exclusive Pin-Dot pre-tuning feature. Wideband allows equal "pick-up" power for all stations on the dial.

AM/FM Narrowband Tuning Position

The Q also provides you with the ability to pick up the hard-to-get radio stations and achieve the best possible signal with the least amount of noise with Pin-Dot Pre-tuning. Pin-Dot pre-tuning allows you to manually 'fine tune' in weaker stations.

To set the Antenna to narrowband mode and take advantage of Pin-dot pre-tuning, adjust the bottom dial counter-clockwise to the Narrowband position. You are in Narrowband mode when all LEDs are green except for one red LED. You 'fine tune' a station by positioning the single red LED like a dial on a tuner. The left most LED is 88MHz and the LED furthest right represents 108MHz.

Example: If the station you want to fine tune is 93.5 then position the red LED between the left and the center green LEDs

NOTE: When using Pin-Dot Pre-Tuning for AM reception make sure the "AM Wing" is laying flat. This enables the 'Non-Conduction' circuitry which minimizes interference caused by the FM and AM antennas being too close together.