Operating Instructions for PRO9246CH Keyless Entry System

Operating Instructions for PRO9246CH Keyless Entry System
Arming the System: (Active)	Turn the ignition key off, exit the vehicle, and close all doors.  Press and release the Lock button on the key chain transmitter. The doors will lock, the LED will begin to flash slowly and the vehicle's parking lamps will flash once, if the optional parking light flasher was added. The horn will beep once if the optional horn annunciation circuit as added.
Arming the System: (Passive)	Passive (Automatic) arming and locking is a selectable feature and may not be activated in your vehicle. Turn the ignition key off, exit the vehicle, and close all doors. Note: Automatic passive arming will not begin until all doors are closed, allowing passenger to exit the vehicle at their convenience. The LED will begin to flash rapidly, 30 seconds later the system is armed, the vehicle's parking lamps will flash one time if the optional parking light flasher was added. Note: The Keyless Entry control module can be programmed to either automatically lock the doors during step 2 above or only lock the doors when step 3 is executed. If you wish to Lock/Arm the system immediately, simply press and release the Lock button on the key chain transmitter. The doors will lock, the LED will begin to flash and the vehicle's parking lamps will flash once and the horn will beep once if those options were added.
Protection while the system is armed:	Whenever the system is armed, the vehicle's starter will be bypassed (optional). If a thief should attempt, the vehicle cannot be started.
Disarming the System:	As you approach the vehicle, press and release the Unlock button on the key chain transmitter. The LED will turn off, the vehicle's parking lamps will flash 2 times (if added), the doors will unlock and the vehicle's interior courtesy light will turn on for approximately 20 seconds, indicating that the system is disarmed. The horn will also beep once if the option was added. Note: If the passive arming feature is activated in your vehicle, the LED will begin to flash rapidly when the unlock button is pressed. Opening any door will suspend the arming process. Note: If the optional 2-step unlock feature was installed, then only the driver's door will unlock during step 1 above. To unlock all doors, press the unlock button of the transmitter a second time. Never attempt to disarm the system from a distance that prevents you from opening a door within 30 seconds, when the system is programmed for passive arming as the system will begin to re-arm until a door is opened. Opening the door will suspend the passive arming cycle.
Car Finder:	As an added convenience, your system has the ability to flash the parking lights and sound the vehicle's horn (if these options have been added) on command from the transmitter. This feature is particularly useful to help locate your vehicle in a crowded parking lot. To access this feature, simply press and hold the lock or unlock button of your key chain transmitter for three seconds. This mode will cancel automatically after 30 seconds, or you can cancel it from the transmitter by pressing the same transmitter button again for three seconds.