Operating the Audiovox LCMR4N Rearview Mirror and Navigation Monitor

Operating the Audiovox LCMR4N

The Mirror/monitor is ready for operation every time the Ignition key is turned on. The mirror/monitor turns off every time the Ignition is turned to the off position.

SW1 and SW2

SW1: Turn on the Navigation display timer mode. When SW1 is pressed, the LED will turn yellow. The navigation image will appear for the preset time 30 sec, 2.5 minutes or 5 minutes. Once the preset time has expired, the LCD will turn off. The navigation image will reappear with the next voice command prompt from the navigation computer.

SW2: Turns the navigation screen image on and off. Press once to turn on the continuous Navigation display. Press again to turn off the Navigation display. Then press SW1 1 if you want to engage the Voice command navigation display timer.

Navigation Voice command display timer: There is a three-position switch located on the front right of the mirror/monitor. The three settings are 30 seconds, 150 seconds and 300 seconds. The vehicle operator can select to engage the navigation display timer by pressing SW1 1. The navigation display will appear for the preset time whenever the navigation system issues an audible voice command.

Cellular Phone Hands-Free Operation

1. Attach the round metal adhesive disc to the back of your mobile phone while not in use, and then attach the mobile phone adhesive magnetic mount to your selected spot of the dash area. By placing your cell phone with the metal disc over the center of the magnetic seat, your cell phone will be attached tightly to the dash.
2. Plug in the 2.5mm hands free cable into your cell phone headset jack. The other end of this cable should be connected to the mirror jack. Note. If your cell phone does not have a 2.5mm headphone jack then an adapter must be used for your particular cell phone. Also not all cell phones are compatible with this mirror hands-free circuit.
3. To answer a call, press the receiving button on your cell phone as usual, the hands free system will engage automatically.
4. The volume of the other party’s voice can be adjusted by turning the volume control under the bottom of the mirror on the right side. It may be necessary to adjust phone volume.
5. To end the call, press the hang-up button. The hands free function will turn off automatically and several seconds later the system will go back to its original audio input.
6. For the different mobile phone, the quality of hands free voice can be adjusted by switching the H-MIC-L switch L.

Volume Control

The volume adjustment control is on the right side of the bottom of the rearview mirror. Rotating the wheel to the right will decrease the sound level. Rotating the wheel to the left will increase the volume.

LCD Monitor Brightness Control

The brightness adjustment control is on the left side of the bottom of the rearview mirror. Rotating the wheel to the right will decrease the brightness. Rotating the wheel to the left will increase the brightness.