Information, Programming Guide and Support for the Code Alarm CATX120 Transmitter

Information on the Code Alarm CATX120 Transmitter
	CATX120 Programming Guide
Programming Instructions: To program new or additional transmitters, the alarm must be disarmed and the valet switch must be in the OFF position: Enter the vehicle, and turn the ignition key to the ON position. Press and release the valet/programming/override switch 3 times. The dash LED will flash one time, and the sounding device will beep onetime, indication the system is ready to accept programming for transmitter 1. Press and hold the Arm Icon button until the sounding device emits a long beep, indicating the signal has been stored into memory. If you have additional transmitters (up to 4) that need to be programmed, repeat step 4 for each transmitter.
Register Your Product