Installing the RCA MAF15BKR TV Mount

Installing the RCA MAF15BKR TV Mount

CAUTION: This wall mount is intended for use only with the maximum weight of 25 kg/55 lbs. Use with heavier than the maximum weights indicated may result in instability causing possible injury. Follow the installation and operation instructions carefully.

Safety Precautions 

Follow these precautions to ensure safe installation and mounting of your fl at panel TV.

1. Read these instructions carefully before you begin. If you are unsure of any part of the process, contact a professional contractor or installer for assistance. Improper installation can result in injury or damage.
2. The wall or mounting surface must be capable of supporting the combined weight of the mount and the display; if not, the structure must be reinforced.
3. Safety gear and proper tools must be used. Failure to do so can result in injury and/or damage. A minimum of two people are required for installation. Do not attempt to install this mount alone under any circumstances.
4. Follow all instructions and recommendations regarding adequate ventilation and suitable locations for mounting your display. Consult the owner‘s manual for your particular display for more information.
5. For drywall installation, it is essential for the wall mount plate to be attached to wall studs. (Use a stud finder.)
6. Use the included hardware for mounting purposes. This hardware has been provided to ensure a safe and secure mount.
7. Hire a licensed electrician to relocate an electrical outlet, if needed.
8. Be sure to purchase wires long enough to connect the TV to the audio and video components in your installation.

Mounting the Wall Plate

Drywall Installation:

Important! For safety reasons, this mount must be secured to at least two wood studs no less than 16” apart. The studs must be capable of supporting the combined weight of the mount and display.

1. Use a high quality stud finder to locate two adjacent studs where you wish to install your mount. Mark both edges of each stud to help identify the exact center. NOTE: You must use the center of each stud to avoid cracking or splitting the wood during installation.
2. Place the wall plate against the wall and level it using the integrated bubble level.
3. While another person holds the wall plate in position, mark four locations (two per stud) for securing the mount to the wall.
4. Set the wall plate aside and drill a 3/16” pilot hole at each marked location.
5. Place the wall plate back against the wall and attach it using the lag bolts (F) and lag bolt washers (H) (see Fig. 1). Do not over-tighten these bolts and do not release the wall plate until all bolts are in place. Ensure that the wall plate remains level after all bolts are secured.

Concrete/Brick Installation:

Important! For safety reasons, the concrete wall must be capable