Operating Instructions for the Prestige APS996A Remote Start Security System

Operating the Prestige APS996A Remote Start System
Arming the APS996A - Active	Turn off the engine, exit the vehicle, and close all doors, hood lid and trunk lid. Press and release Lock/Arm button on the keychain transmitter. The dash mounted LED begins to flash slowly. Parking Lights flash one time. Siren sounds one chirp. If the siren sounds 3 chirps, then you have left a door, trunk or hood lid ajar. Simply close the opened entry point to provide full protection. If the siren did not sound when arming, then the chirps have been turned off and you should refer to the section titled “ELIMINATING THE ARM / DISARM CHIRPS“ below. Doors Lock is Optional. Note: If the optional Headlamp illumination feature has been added, and has been selected for operation when arming, as an added convenience, the system will turn on the headlights when the system is armed.
Silent Arming the APS996A - Active	(Must be activated during programming) Turn off the engine, exit the vehicle and close all doors, hood lid and trunk lid. Press and hold the Lock/Arm button on the keychain transmitter for 2 seconds. The dash mounted LED begins to flash slowly. Parking Lights flash one time. Siren will not sound. If the siren sounds 3 chirps, then you have left a door, trunk, or hood lid ajar. Simply close the opened entry point to provide full protection. Doors Lock is Optional. Note: If the optional Headlamp illumination feature has been added, and has been selected for operation when arming, as an added convenience, the system will turn on the headlights when the system is armed.
Arming the APS996A - Passive (Automatic)	Turn off the engine, exit the vehicle and close and lock all doors, hood lid and trunk lid. The dash mounted LED begins to flash rapidly, indicating 30 second passive arming has begun. Opening any protected entry point during the 30 second passive arming cycle will immediately suspend automatic arming and the 30 second passive arming cycle will re-start when all doors are closed. At the end of the passive arming cycle; The dash mounted LED begins to flash slowly. Parking Lights flash one time. Siren sounds one chirp. If the siren did not sound when arming, then the chirps have been turned off and you should refer to the section titled “ELIMINATING THE ARM / DISARM CHIRPS“ below. Doors Lock is Optional. Door locking during passive arming is a selectable feature. The alarm can be programmed to allow the doors to lock only when arming using the keychain transmitter and they will not automatically lock during passive arming.
Protection While the APS996A is Armed	Opening any protected door, hood or trunk lid will cause the alarm to immediately sound. The alarm will continue to sound for 30 seconds, then stop and continue to monitor all protected entry points. If the thief left a door opened, the alarm will sound for six 30 second cycles, remain armed and ignore that triggered zone. Whenever the system is armed, the red dash m