|
ARMING THE SYSTEM - ACTIVE:
- Turn off the engine, exit the vehicle, and close all doors, hood lid, and trunk lid.
- Press and release the Lock button on the keychain transmitter.
SILENT ARMING - ACTIVE:
- Turn off the engine, exit the vehicle, and close all doors, hood lid, and trunk lid.
- Press and hold the Lock button on the keychain transmitter for 2 seconds.
ARMING THE SYSTEM - PASSIVE (AUTOMATIC):
- Turn off the engine, exit the vehicle, and close and lock all doors, hood lid, and trunk lid. Red dash mounted LED begins to flash rapidly, indicating 30 second passive arming has begun.
- Opening any protected entry point during the 30 second passive arming cycle will immediately suspend automatic arming, and the 30 second passive arming cycle will re-start when all doors are closed. At the end of the passive arming cycle: Red dash mounted LED begins to flash slowly. Parking Lights flash one time. Siren sounds one chirp. If the siren did not sound when arming, then the chirps have been turned off, and you should refer to the section titled "ELIMINATING THE ARM / DISARM CHIRPS" below.
PROTECTION WHILE THE SYSTEM IS ARMED:
- Opening any protected door, hood, or trunk lid will cause the alarm to immediately sound. The alarm will continue to sound for 30 seconds, then stop and continue to monitor all protected entry points. If the thief left a door opened, the alarm will sound for six 30 second cycles, remain armed, and ignore that triggered zone.
- Whenever the system is armed, the red dash mounted LED indicator will slowly flash. This serves as a visual deterrent to the potential thief. The LED is a very low current bulb, and will not cause the vehicle’s battery to drain, even when left unattended for extended periods.
- Whenever the system is triggered, the vehicle’s parking lights will flash for the full 30 second alarm cycle, attracting visual attention to the vehicle.
- Whenever the system is triggered, the vehicle’s horn will beep for the full 30 second alarm cycle, attracting added attention to the vehicle.
- Optional - Whenever the system is triggered, the interior courtesy lights will flash for the full 30 second alarm cycle.
- Whenever the system is armed, the vehicle’s starting circuit will be bypassed. If the thief should choose to ignore the siren, the vehicle can not be started.
- Optional - Any strong impact to the vehicle’s glass will cause the alarm to trigger for the full 30 second alarm cycle.
DISARMING THE SYSTEM:
- As you approach the vehicle, press and release the Unlock button on the keychain transmitter.
SILENT DISARMING:
- As you approach the vehicle, press and hold the Unlock button on the keychain transmitter for 2 seconds. Red dash mounted LED turns off. If passive arming was selected during the installation, then the LED will start flashing rapidly, indicating that the system is re-arming automatically. Open any door to suspend the automatic arming. Parking Lights flash two times. If the parking lights flashed three times, then the alarm was triggered in your absence. Before turning the key on, examine the LED to identify which zone was triggered. Siren will not sound. If the siren sounds 4 chirps, then the alarm was triggered in your absence. Before turning the key on, examine the LED and refer to the INTRUSION WARNING SIGNALS section below to identify which zone was triggered.
WHILE THE SYSTEM IS SOUNDING: If during a triggered state, you
|
Comments
0 comments
Article is closed for comments.