Operating Instructions for the Pursuit PRO2KKD Security System

Operating the Pursuit PRO2KKD Security System

Arming the System: 

1. Turn off the engine, exit the vehicle and close all doors, hood lid and trunk lid.
2. Press and release the Lock button on the key chain transmitter. Red dash mounted LED begins to flash slowly. Parking Lights flash one time. Siren sounds one chirp. If the siren/horn sounds 3 chirps, then you have left a door, trunk, or hood lid ajar. Simply close the opened entry point to provide full protection. If the siren "chirped" three times, sometime after arming, the exclusive delayed dome light learn circuit has been programmed and the system detected a open entry point after the learned delay expired. Again, closing the hood, trunk, or doors will correct the problem and you do not need to disarm the system to make the correction. If the siren/ horn did not sound when arming, then the chirps have been turned off and you should refer to the section titled "ELIMINATING THE ARM/DISARM CHIRPS" in this manual. Doors Lock .

Arming the System (Passive):

1. Turn off the engine, exit the vehicle, and close and lock all doors, hood lid and trunk lid. Red dash mounted LED begins to flash rapidly, indicating thirty second passive arming has begun.
2. Opening any protected entry point during the thirty second passive arming cycle will immediately suspend automatic arming and the thirty second passive arming cycle will re-start when all doors are closed. At the end of the passive arming cycle: Red dash mounted LED begins to flash slowly. Parking Lights flash one time. Siren sounds one chirp. If the siren did not sound when arming, then the chirps have been turned off, and you should refer to the section titled “ELIMINATING THE ARM / DISARM CHIRPS” in this manual. Doors Lock. Door locking during passive arming is a selectable feature. The alarm can be programmed to allow the doors to lock only when arming using the key chain transmitter, and they will not automatically lock during passive arming.

Silent Arming:

1. Turn off the engine, exit the vehicle and close all doors, hood lid, and trunk lid.
2. Press and hold the Lock button on the key chain transmitter for 2 seconds. Red dash mounted LED begins to flash slowly. Parking Lights flash one time. Siren will not sound. However, if the siren "chirped" three times, sometime after arming, the exclusive delayed dome light learn circuit has been programmed and the system detected a open entry point after the learned delay expired. Closing the hood, trunk, or doors will correct the problem and you do not need to disarm the system to make the correction. Doors Lock.

Intrusion Warning Signals:

This system will inform you if an intrusion attempt has occurred while you were away from the vehicle. If an intrusion attempt has occurred, the siren will chirp 4 times and the parking lights will flash 3 times when disarming the system. Enter the vehicle and observe the red dash mounted LED to identify which zone was triggered.

1. If the LED is flashing one time...pause...one time...pause...etc., then an intrusion attempt was made to the one of the pin switches typically installed under the hood or in the trunk, or an optional sensor connected to the unit.
2. If the LED is flashing two times...pause...two times...pause...etc., then an intrusion attempt was made to a hood or trunk pin switch that was added to the system, or to a light act