|
Using Your Remote Control
ARMING THE SYSTEM: (ACTIVE)
- Turn the ignition key off, exit the vehicle, and close all doors.
- Press and release the Lock button on the keychain transmitter.
- The siren and or horn will beep one time, the parking lamps will flash one time, and the LED found on the glass mounted receiver will begin to slowly flash, indicating that the system is ARMED.
- Any time the door lock switch in the vehicle is used to lock the doors while the ignition key is turned off, the system will immediately arm. To lock the doors after entering the vehicle, make sure the ignition key is switched on first. Turning the ignition key on first will stop the system from arming.
ARMING THE SYSTEM: ( PASSIVE )
- Turn the ignition key off, exit the vehicle, and close all doors.
- The LED will begin to flash rapidly, indicating that the system is automatically ( passively ) arming. As an added convenience, the 30 second automatic passive arming will not begin until all doors are closed, allowing passengers to exit the vehicle at their convenience.
- In 30 seconds, you will hear a single short chip from the siren, and the vehicle’s parking lamps will flash one time, indicating that the system has ARMED. At this time, the dash mounted PRLED will begin to flash slowly, providing a visual indication that the system is fully armed.
- It is possible to program the system, that when the alarm is allowed to automatically passive arm, there will be a 15 second delay after a door is opened before the alarm will sound. However, if the system is programmed for instant trigger there will be no delay. Check with your installer for the setting of this feature.
IMPORTANT! When the system is programmed for passive arming, the system will always arm, even when the keychain transmitter has not been used to lock the doors. When you leave the vehicle, and a door has been left opened, the system will arm after 10 minutes. If you plan to vacuum the car, or if service work is being performed, either leave the key in the ignition and switched to the on position, or put the system into valet mode. If you do not do this, the system will arm in 10 minutes, and you may inadvertently trip the alarm.
PROTECTION WHILE THE SYSTEM IS ARMED:
- Opening any door, hood, or trunk will cause the alarm to immediately sound. The alarm will continue to sound for 30 seconds, then stop and automatically rearm the vehicle. If the potential thief left a door opened, the alarm will sound for three more 30 second cycles, then re - arm and ignore the opened door zone.
- Whenever the system is armed, the on glass receiver's LED indicator will slowly flash. This serves as a visual deterrent to the potential thief. The LED is a very low current bulb, and will not cause the vehicle’s battery to drain, even when the vehicle is left unattended for extended periods.
- Whenever the system is triggered, the vehicle’s parking lights will flash for the 30 second alarm cycle, attracting added visual attention to the vehicle.
- Whenever the system is armed, the vehicle’s starter will be disabled. The vehicle will not start.
DISARMING THE SYSTEM:
- As you approach the vehicle, press and release the unlock button on the keychain transmitter.
- The siren and or horn will beep two times, the parking lamps will flash two times, and the on glass receiver'
|
Comments
0 comments
Article is closed for comments.