Operating the Code Alarm PRO9801N Remote Start System

Operating the Code Alarm PRO9801N Remote Start System

Using Your Remote Transmitter

ARMING THE SYSTEM - ACTIVE:

1. Turn off the engine, exit the vehicle, and close all doors, hood lid and trunk lid.
2. Press and release Lock/Arm button on the keychain transmitter.

SILENT ARMING - ACTIVE (Must be activated during programming):

1. Turn off the engine, exit the vehicle and close all doors, hood lid and trunk lid.
2. Press and hold the Lock/Arm button on the keychain transmitter for 2 seconds.

ARMING THE SYSTEM - PASSIVE (AUTOMATIC) (Must be activated during programming):

1. Turn off the engine, exit the vehicle and close and lock all doors, hood lid and trunk lid. The dash mounted LED begins to flash rapidly, indicating 30 second passive arming has begun.
2. Opening any protected entry point during the 30 second passive arming cycle will immediately suspend automatic arming and the 30 second passive arming cycle will re-start when all doors are closed. At the end of the passive arming cycle: The dash mounted LED begins to flash slowly. Parking Lights flash one time. Siren sounds one chirp. If the siren did not sound when arming, then the chirps have been turned off and you should refer to the section titled “ELIMINATING THE ARM / DISARM CHIRPS“.

PROTECTION WHILE THE SYSTEM IS ARMED:

• Opening any protected door, hood or trunk lid will cause the alarm to immediately sound. The alarm will continue to sound for 30 seconds, then stop and continue to monitor all protected entry points. If the thief left a door opened, the alarm will sound for six 30 second cycles, remain armed and ignore that triggered zone.
• Whenever the system is armed, the dash mounted LED indicator will slowly flash. This serves as a visual deterrent to the potential thief. The LED is a very low current bulb and will not cause the vehicle’s battery to drain, even when left unattended for extended periods.
• Whenever the system is triggered, the vehicle’s parking lights will flash for the full 30 second alarm cycle, attracting visual attention to the vehicle.
• Optional - Whenever the system is armed, the vehicle’s starting circuit will be bypassed. If the thief should choose to ignore the siren, the vehicle can not be started.
• Any mild impact to the vehicle’s glass will cause the alarm to sound a short series of warning tones.
• Any strong impact to the vehicle’s glass will cause the alarm to trigger for the full 30 second alarm cycle.

DISARMING THE SYSTEM: As you approach the vehicle, press and release the Unlock/Disarm button on the keychain transmitter.

SILENT DISARMING (Must be activated during programming): Press and hold button the Unlock/Disarm button on the keychain transmitter for 2 seconds.

WHILE THE SYSTEM IS SOUNDING: If during a triggered state, you wish to shut off the siren without disarming your security system, simply press and release any transmitter button other than the Unlock/Disarm button. This action will turn off the siren yet leave the vehicle fully armed and protected. This feature is particularly useful if you are aware of children playing near your vehicle that may accidentally trigger your security system. In this case you can cancel the siren sounding without disarming your alarm.

INTRUSION WARNING SIGNALS: This system will inform you if an intrusion attempt has occurred while you were away from the vehicle. If an intrusion attempt has occurred, the siren will chirp 4 times and the parking ligh