Operating the Code Alarm PROF65 / F65 Alarm System

Operating the Code Alarm PROF65 / F65 Alarm System

Using Your Remote Transmitter

Arming the Security System: To arm the system, exit the vehicle, close all doors, then press the ARM button. The horn will “chirp” twice and the parking lights will flash twice, indicating the system is armed. The doors will also lock at this time (if equipped and connected). The status indicator (red warning light on the dash) will blink steadily, once per second.

Pre-arm Mode: If the horn chirps and the parking lights flash only once, this indicates that the vehicle courtesy light is on, or that an entrance is not closed securely. Check to see that doors, hood, and trunk are properly closed. Once all entrances are secured (and the courtesy light is off), the system will chirp / flash again. The system is now fully armed. (If the entrance is not secured within 4 minutes, the system will arm and ignore the unsecured entrance until it is closed.)

Disarming the Security System: To disarm the system, press the DISARM button. The horn will chirp and the parking lights will flash once, and the doors will unlock. The courtesy light will turn on for 1 minute, or until the vehicle is started.

Attempted Intrusion Identification: If the horn chirps four times when disarming, this indicates that the system was triggered in your absence. The status indicator will also flash rapidly. Perform the following operation to determine the protected zone that triggered the system: After disarming, press the emergency override button. The horn will chirp to indicate the cause of the alarm trigger: 1 chirp = IT-s Interior Theft Sensor, 2 chirps = Door, 3 chirps = Hood, 4 chirps = Trunk/Optional Sensors, 5 chirps = Ignition was turned on.

Disabling the IT-s Interior Theft Sensor: It may be necessary at times to disable the IT-s Interior Theft Sensor, especially when parking in areas (like parking garages) where extreme vibration may cause false alarms. Press the ARM button and then press the FIND/PANIC button within two seconds of pressing ARM to disable the interior theft sensor. The horn will chirp three times to indicate that the sensor is disabled. The sensor will become enabled again the next time the system is armed normally.

Two-Stage Door Unlock: If this feature is enabled on your system, pressing DISARM one time will unlock only the driver’s door. Press DISARM again within 1 minute to unlock all doors.

Activating the Trunk Release Feature: Press and hold TRUNK to open the vehicle trunk or hatch (if equipped and connected). If this button is used to operate another accessory, the accessory will stay active for as long as the button is held.

Using the Car Finder Feature: Press FIND on the remote control to locate your vehicle. The horn will emit five short chirps.

Personal Protection Alarm (Panic): Press and hold the PANIC button to activate the vehicle horn and parking lights for 30 seconds. (If the vehicle horn is connected, the horn will “pulse” for 30 seconds.) Press any remote control button to turn off the Panic alarm.

Remote Start / Stop Feature: Press and hold the START button on the remote control. If all safety parameters are correct, the engine will start within 5 seconds (diesel engines will take longer.) Press and hold the START button again to turn the vehicle off. (Turn to page 6 for more on remote start features.)

Thank you for your inquiry - Audiovox values our customers and though this product is no longer in production nor does it qualifiy for warranty or repair due to the age of the product, limited support information may be available through our FAQ Database and/or Customer Service.

Before you proceed check this and other answers related to your product by searching with the Model Number of your product from the Search Box above.

NOTE: Technical support, parts, user manuals (not shown on this FAQ), accessories, or repairs are either limited or NOT available for discontinued models.