Operating the Code Alarm PROF17 / F17 Security System

Operating the Code Alarm PROF17 / F17 Security System

Using Your Remote Transmitter

Arming the Security System: To arm the system, exit the vehicle, close all doors, then press the ARM button. The horn/siren will “chirp” twice and the parking lights will flash twice, indicating the system is armed. The doors will also lock at this time (if equipped and connected). The status indicator (red warning light on the dash) will blink steadily, once per second.

Pre-arm Mode: If the horn/siren “chirps” and the parking lights flash only once, this indicates that the vehicle courtesy light is on, or that an entrance is not closed securely. Check to see that doors, hood, and trunk are properly closed. Once all entrances are secured (and the courtesy light is off), the system will “chirp” / flash again. The system is now fully armed. (If the entrance is not secured within 4 minutes, the system will arm and ignore the unsecured entrance until it is closed.)

Disarming the Security System: To disarm the system, press the DISARM button. The horn/siren will “chirp” once and the parking lights will flash once, and the doors will unlock. The courtesy light will turn on for 1 minute, or until the vehicle is started.

Attempted Intrusion Identification: If the horn/siren “chirps” four times when disarming, this indicates that the system was triggered in your absence. The status indicator will also flash rapidly. Perform the following operation to determine the protected zone that triggered the system: After disarming, press the emergency override button. The horn/siren will “chirp” to indicate the cause of the alarm trigger: 1 chirp = IT-s Interior Theft Sensor, 2 chirps = Door, 3 chirps = Hood, 4 chirps = Trunk/Optional Sensors, 5 chirps = Ignition was turned on.

Disabling the IT-s Interior Theft Sensor: It may be necessary at times to disable the IT-s Interior Theft Sensor, especially when parking in areas (like parking garages) where extreme vibration may cause false alarms. Press the ARM button. Then press the ARM and DISARM button again, within two seconds, to disable the interior theft sensor. The horn/siren will chirp three times to indicate that the sensor is disabled. The sensor will become enabled again the next time the system is armed normally.

Activating the Trunk Release Feature: Press and hold the DISARM button to open the vehicle trunk or hatch (if equipped and connected). If this button is used to operate another accessory, the accessory will stay active for as long as the button is held.

Personal Protection Alarm (Panic): Press and hold the BOTH buttons to activate the vehicle horn and parking lights for 30 seconds. Press any remote control button to turn off the Panic alarm.

Using Valet Mode: If the Passive Arming feature is enabled on your system, Valet mode temporarily prevents the alarm system from arming automatically. This is useful when fueling or servicing your vehicle.

• To enter Valet Mode: With the vehicle ignition on, press the ARM button. The status indicator will emit a quick double-flash pattern. Note: In Valet mode, all keyless entry, convenience and remote start features operate normally.
• To exit V