Operating the Code Alarm CA330 Keyless Entry Upgrade

Operating the Code Alarm CA330 Keyless Entry Upgrade

Using Your OEM Remote Control Transmitter

Arming the Security System: To arm the system, exit the vehicle, close all doors, then press the LOCK button on your OEM Keyless Entry Remote Control. The horn will “chirp” twice and the parking lights will flash twice, indicating the system is armed. The status indicator (red warning light on the dash) will blink steadily, once per second.

Pre-arm Mode: If the horn chirps and the parking lights flash only once, this indicates that the vehicle courtesy light is on, or that an entrance is not closed securely. Check to see that doors, hood, and trunk are properly closed. Once all entrances are secured (and the courtesy light is off), the system will chirp / flash again. The system is now fully armed. (If the entrance is not secured within 4 minutes, the system will arm and ignore the unsecured entrance until it is closed.)

Disarming the Security System: To disarm the system, press the UNLOCK button on your OEM Keyless Entry Remote Control. The siren will chirp and the parking lights will flash once.

Attempted Intrusion Identification: If the horn chirps four times when disarming, this indicates that the system was triggered in your absence. The status indicator will also flash rapidly. Perform the following operation to determine the protected zone that triggered the system: After disarming, press the emergency override button. The horn/siren will chirp to indicate the cause of the alarm trigger: 1 chirp = IT-s Interior Theft Sensor, 2 chirps = Door, 3 chirps = Hood, 4 chirps = Trunk/Optional Sensors, 5 chirps = Ignition was turned on.

When Your Security System is Triggered

The CA330 will trigger if one of the following events occurs while the system is armed:

• Any protected entrance is opened
• The vehicle ignition is turned on
• The vehicle is jolted hard enough to signal the impact detector

Once the alarm is triggered, the siren (or horn) sounds and the vehicle parking lights flash for 30 seconds. The system will then rearm, awaiting the next intrusion attempt.

To stop the siren while keeping the alarm armed and doors locked: press the LOCK button (on the OEM Keyless Entry Remote) while the system is triggered.

Using Valet/Service Mode

Valet Service mode is used to disable your systems security functions when your vehicle is being serviced or valet parked.

To engage valet/service mode:

1. Turn the ignition key to the RUN position (last position before start) then OFF three (3) times within 10 seconds.
2. The status indicator (red dashboard mounted LED light) will emit a double flash sequence to indicate the systems has entered valet/service mode.

To disengage valet/service mode:

1. Turn the ignition key to the RUN position (last position before start) then OFF three (3) times within 10 seconds.
2. The status indicator (red dashboard mounted LED light) will turn off to indicate the systems has exited valet/service mode.
3. The security system will arm normally the next time the LOCK button is pressed on the OEM remote control transmitter.

</td