Programming the Pursuit PROOE2 Transmitter

Programming the Pursuit PROOE2 Transmitter

The transmitters included with the system have been pre-programmed at the factory, with each button pre-assigned to control a specific function of the system. Although the system in the vehicle has either a 2 or 3 channel receiver, depending on the model, the transmitters included with the system are capable of transmitting 3 distinct signals. This allows you to program each transmitter to more than one vehicle in two car families, and also allows you to change which button(s) control certain functions of the system. (Example: Transmitter channel 3 can be programmed to activate Receiver channel 2.) Refer to the chart below for access to each of the transmitter channels, and for the standard factory button assignments.

** Only Available With Some Systems

PROGRAMMING THE TRANSMITTERS

It is important to remember that during programming, each individual step of the procedure must be executed within 15 seconds of the previous step. When the 15 second time limit is allowed to expire, the system will automatically terminate the programming mode.This is indicated by a long chirp from the siren.

Additionally, the system will store codes from up to four different transmitters. If a 5th transmitter is programmed to any receiver channel, then the first transmitter programmed to that channel will be erased from the system’s memory.

NOTE: Some Keyless Entry Units do not include a sounding device therefore may not respond with beep tones where indicated below. Simply follow the procedure and where indicated, press and hold the transmitter button for 3 seconds.

To program new or additional transmitters:

1. Enter the vehicle, and turn the ignition key to the " on " position.
2. Flip the valet switch on - off - on - off - on - then off.
3. The dash LED will flash one time, and the sounding device will beep one time, indicating the system is ready to accept programming for receiver channel 1.
4. Press and hold the Lock/Unlock Icon button until the sounding device emits a long beep, indicating the signal has been stored into memory.
5. If you have additional transmitters (up to 4) that need to be programmed, repeat step 4 for each transmitter.
6. Flip the valet switch on then off.
7. The dash LED will flash two times, and the sounding device will beep two times, indicating the system is ready to accept programming for receiver channel 2.
8. Press and hold the Option transmitter button until the sounding device emits a long beep, indicating the signal has been stored into memory.
9. If you have additional transmitters (up to 4) that need to be programmed, repeat step 8 for each transmitter.
10. Flip the valet switch on then off. The dash LED will flash three times, and the sounding device will beep three times, indicating the system is ready to accept programming for receiver channel 3 (only available on certain models).
11. If you have additional transmitters (up to 4)that need to be programmed, repeat step 10 for each transmitter.
12. Turn the ignition key off. The sounding device will emit one short beep followed by one long beep indicating the system has terminated the program mode.