Operating the Code Alarm CA545 Remote Start Security System

Operating the Code Alarm CA545 Remote Start Security System

Using Your Remote Control

Arming the Security System: To arm the system, exit the vehicle, close all doors, then press the LOCK icon button on the remote control. The system will sound twice and the parking lights will flash twice, indicating the system is armed. The doors will also lock at this time (if equipped and connected). The status indicator (blue warning light on the dash) will blink steadily, once per second. To arm the system silently, press and hold the LOCK icon button for 1 second. The parking lights will flash 2 times, indicating the system is armed, has locked the doors (if equipped and connected) and activated the starter disable feature. The status indicator (blue warning light on the dash) will blink steadily, once per second. When using the 2-way confirming LED remote control the LOCK icon will flash 1 time and the remote control will beep/vibrate 1 time. The LOCK icon LED on the remote control will flash 1 time every 10 seconds to indicate the system is armed and the vehicle doors are locked.

Pre-arm Mode: If the horn system sounds and the parking lights flash only once, this indicates that the vehicle’s interior light is on or an entrance is left open. Check to see that all doors hood and trunk are closed properly. Once all entrances are secured (and the interior light is off), this system will sound/flash again. The system is now fully armed. (If the entrance is not secured within 4 minutes, the system will arm and ignore the unsecured entrance until it is closed.)

Disarming the Security System: To disarm the system press the UNLOCK icon button. The system will sound and the parking lights will flash once, and the doors will unlock (if equipped and connected). To disarm the system silently, press and hold the UNLOCK icon button for 1 second. The parking lights will flash, indicating the system is disarmed and has unlocked the doors (if equipped and connected). When using the 2-way confirming LED remote control the UNLOCK icon will flash 1 time and the remote control will beep/vibrate 2 times. The UNLOCK icon LED on the remote control will flash 1 time every 10 seconds to indicate the system is armed and the vehicle doors are locked.

Disabling/Enabling Confirmation Chirps:

1. Turn the ignition key ON then OFF.
2. Within 10 seconds push and release the valet/override button 3 times.
3. The system will sound 2 times to disable confirmation chirps or 1 time to enable confirmation chirps.

Attempted Intrusion Identification: This system will inform you if an intrusion attempt has occurred while you were away from the vehicle. If an intrusion attempt occurred, the system will sound 4 times and the parking lights will flash 3 times when disarming the system. Enter the vehicle an observe the dash mounted status LED to Identify which zone was triggered.

1. IT-s Sensor- 1 flash, pause 1 flash, etc.
2. Hood or Trunk Pin switch- 2 flashes, pause 2 flashes, etc.
3. Door Entry- 3 flashes, pause 3 flashes, etc. The intrusion warning indicators are stored in the system’s memory and will be erased when the ignition key is turned on.

Two Stage Door Unlock: If this feature is enabled on your system, pressing the UNLOCK icon button one time on the remote control will unlock only the driver’s door. Press di