Operating the Code Alarm CA611 Remote Start Security System

Operating the Code Alarm CA611 Remote Start Security System

Using Your Transmitter

ARMING THE SYSTEM:

1. Turn the engine OFF, exit the vehicle, and close all doors, hood and trunk.
2. Press and release the Arm button of your transmitter one time. The parking lights will flash once, the siren will chirp once, and the LED will begin to flash slowly confirming the system is armed. If you have the optional door lock/unlock circuit installed, the doors will lock. NOTE: If the siren/horn sounds 3 chirps, then you have left a door, trunk, or hood ajar. Simply close the opened entry point to provide full protection. If the siren "chirped" 3 times, sometime after arming, the exclusive delayed dome light learn circuit has been programmed and the system detected a open entry point after the learned delay expired. Again, closing the hood, trunk, or doors will correct the problem and you do not need to disarm the system to make the correction. If the siren/horn did not sound when arming, then the chirps have been turned off and you should refer to the section titled "ELIMINATING THE NORMAL ARM/DISARM CHIRPS".

SILENT ARMING:

1. Turn the engine OFF, exit the vehicle, and close all doors, hood and trunk.
2. Press and hold the Arm button of your transmitter for 2 seconds. The parking lights will flash once, and the LED will begin to flash slowly confirming the system is armed. The siren will not chirp. If you have the optional door lock/unlock circuit installed, the doors will lock. NOTE: If the siren/horn sounds 3 chirps, then you have left a door, trunk, or hood ajar. Simply close the opened entry point to provide full protection. If the siren "chirped" three times, sometime after arming, the exclusive delayed dome light learn circuit has been programmed and the system detected a open entry point after the learned delay expired. Again, closing the hood, trunk, or doors will correct the problem and you do not need to disarm the system to make the correction. If the siren/horn did not sound when arming, then the chirps have been turned off and you should refer to the section titled "ELIMINATING THE NORMAL ARM/DISARM CHIRPS".

ARMING THE SYSTEM (PASSIVE): If the passive arming feature has been selected: Turn the engine OFF, exit the vehicle, and close all doors, hood and trunk. The LED will begin to flash rapidly indicating that the 30 second passive arming timer has begun. If the dash mounted LED does not begin to flash rapidly, then you have left a door, hood, or trunk ajar. Closing this entry point will allow the arming cycle will begin. If any entry point is opened during the 30 second arming cycle, arming will be suspended. When all entry points are closed, the arming cycle will begin again. At the end of the 30 seconds, the parking lights will flash once, the siren will chirp once, and the LED will begin to flash slowly confirming the system is armed. If the siren/horn did not sound when arming, then the chirps have been turned off. Refer to the section on "Eliminating the normal Arm/Disarm Chirps" found on page 8 of this manual. Passive door locking is a selectable feature. If you have the optional door lock/unlock circuit installed, the doors may or may not lock passively depending upon the setup during installation.

PROTECTION WHILE THE SYSTEM IS ARMED:

• Opening any protected entry point, hood, trunk, or doors will cause the alarm to trigger immediately. The siren/horn will sound